User's Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion® HSD-440 Mark 2 Terminal
23-15-30 4-58
3 JUN 10
NOTE: When the aircraft is stationary, the field may appear as a series of
asterisks (*).
2. Reports 5 and 17
Report 5 displays information for channel card 1, and report 17 displays
inf
ormation for channel card 2.
These reports are commonly used for testing a
nd troubleshooting the system
and are only available to Level 2, maintenance access users.
You are prompted to select the channel(s) for which to generate a report:
Figure 4-15 Prompt to Select Channel for Report Generation
The options are:
• 1 for channel 1
• 2 for channel 2
• B for both channels
• X to deselect all channels
In report 17 for channel card 2, you can select channel 3, channel 4, both
cha
nnels, or deselect all channels.
NOTE: Depending on the version of software installed and the user's
selection of reports, the MPU reports displayed may differ from those
shown in the example in Figure 4-16.
CHAN #3: C/No= 0.0 dB Hz sig= 0.0 dB log off beam=0 bt=OK oc=NA
tx 0 Hz burst 0 38.0 C int=8080
Figure 4-16 Example of Report 17, Channel Card 2, Channel 3
3. Reports 8 and 20
Report 8 displays the status of the starboard antenna, and report 20 displays
the
status of the port antenna.
HD 83.9D
Aircraft true heading; where the nose of the aircraft is pointing, based on
yaw offset
TK 0.0D
Aircraft true track; direction the aircraft is flying—not necessarily the
direction it is pointing (see note below)
0 knots
Aircraft velocity
5 WHICH GAN CHANNEL (1,2,B,X) ?
Table 4-17 Report 23 Item Descriptions (Continued)
Report 23 Text Description