User's Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion® HSD-440 Mark 2 Terminal
23-15-30 4-53
3 JUN 10
(j) Menu 30
Figure 4-12 shows an example HSD-440 Mark 2 Terminal MPU Menu 30 screen
display.
Table 4-16 describes some of the items available in Menu 30.
NOTE: For more information about PIM testing, refer to "Passive
Intermodulation (PIM) Test" on page 3-16.
MENU 30 FIRMWARE Vx.x GND
L list PIMBIT parameters M initiate manual PIMBIT
F fakeout PIMBIT parameters P initiate/stop PIMBIT
<CTRL> N next menu <CTRL> O previous menu = select reports
Figure 4-12 Menu 30 Screen Display
(6) Report Descriptions
When testing or troubleshooting the HSD-440 Mark 2 Terminal, monitoring real-time
sy
stem data is sometimes required. Figure 4-13 shows all the reports potentially
available to a Level 2 user.
Most reports are used for factory debugging pu
rposes only. This document describes
only the reports typically used in the field for operational and fault isolation testing.
NOTE: Depending on the version of software installed, the MPU reports that appear
may differ from those shown as an example in Figure 4-13.
Table 4-16 Menu 30 Item Descriptions
Menu Item Item Description
L: list PIMBIT
p
arameters
List the parameters used during PIM testing including transmit and receive
channel frequencies.
M: initiate manual
PIMBIT
Start the manual PIM test. Do not use.
N: initiate/stop PIMBIT Start the automatic PIM test.