User's Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion® HSD-440 Mark 2 Terminal
23-15-30 4-50
3 JUN 10
(f) Menu 13
Menu 13 items are used to query and debug the data I/O card.
Figure 4-8 shows an example Menu 13 screen display. Table 4-12 describes the
items available in Menu 13.
MENU 13 1252-A-3800-01 FIRMWARE Vx.x
T query DATA IO elapsed time V query DATA IO version
S query DATA IO services D DATA IO test
F DATA IO fault logging level X DATA IO console mode
G print DATA IO call database Y disable output to DATA I/O
<CTRL> N next menu <CTRL> O previous menu = select reports
Figure 4-8 Menu 13 Screen Display
Table 4-12 Menu 13 Item Descriptions
Menu Item Description
T: query DATA IO elapsed
time
Displays the time (in seconds) sin
ce the last data I/O reset.
S: query DATA IO services Displays active interfaces.
F: DATA IO fault logging
level
Sets the level of minimum severity of
events that are reported to the
data I/O card.
G: print DATA IO call
da
tabase
Displays the calls made and recorded in the data I/O database.
V: query DATA IO version Displays the firmware version of the data I/O card.
D: DATA IO test Tests individual interfaces of the data I/O.
X: DATA IO console mode Opens a virtual TTY session to the data I/O maintenance port on the
HSD-
440 Mark 2 Terminal.
Y: disable output to DATA
I/
O
Disables output to data I/O from control processor.
M: activate antenna
status wo
rds
Activates all set antenna status words.
D: toggle active
an
tenna
Changes the current simulated active antenna. Choose starboard, port, or
automatic. Note that this change will only take effect if antenna status words
are activated using menu item M.
F: IRS bus #1 Do not change
Table 4-11 Menu 10 Item Descriptions (Continued)
Menu
Item Description