User's Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion® HSD-440 Mark 2 Terminal
23-15-30 4-46
3 JUN 10
14 Maintenance port
inverse video
Enables a selected report to be highlighted in Inverse Video
when it is activated—default is 1 (activated).
15 Maintenance port
degrees symbol
Offers a choice of displaying the letter D or the degree
symbol ° when viewing the lat/long information displayed
in the Reports output:
• Select 0 to use the letter D; e.g., 180.0 D.
• Select 1 to use a degree symbol °; e.g., 180.0°.
16 Terminal category Configure the LRU type. Default is 2 (HW Strapping) —
hardware is read on power-up.
20 Card 1 IP address IP address of channel card 1.
21 Card 2 IP address IP address of channel card 2.
22 Transmit if
Weight-on-Wheels
Allows the system to transmit when it is on the ground.
29 Default latitude Allows user to enter a default latitude value.
Reset the HSD-440 Mark 2 Terminal to activate revised
default values.
30 Default longitude Allows user to enter a default longitude value.
Reset the HSD-440 Mark 2 Terminal to activate revised
default values.
31 Obey OXCO status Prevents system operation until OCXO is warmed up
(unless overridden).
Use parameter setting to override warm-up during testing
procedures.
60 Ch card gateway
address
Manufacturer-specific - do not modify.
61 IMEI number Manufacturer-specific - do not modify.
62 SDU-to-PA gain Manufacturer-specific - do not modify.
63 Card 1 subnet address Subnet address of channel card 1.
64 Card 2 subnet address Subnet address of channel card 2.
65 Air/ground behavior Determines the function of WOW strapping.
66 #2 IMEI number Manufacturer-specific - do not modify.
67 #3 IMEI number Manufacturer-specific - do not modify.
68 #4 IMEI number Manufacturer-specific - do not modify.
73 CP auto attach To ensure that the terminal registers on the
SwiftBroadband Circuit-Switched and Packet-Switched
core network, set this option to CS PS. Network
Registration is essential to access network resources to
make calls.
74 CC SBB cipher
parameter
Ciphers the messages between the terminal and the core
network.
Table 4-9 Menu 3, Item M EEPROM Parameter Descriptions (Continued)
Parameter
Number
Parameter Name Description