User's Manual

MISCELLANEOUS PARAMETERS
1 HPA-TO-ANTENNA TOTAL LOSS 21 CARD 2 IP ADDRESS
2 FORWARD ID 22 TRANSMIT IF WEIGHT-ON-WHEELS
3 GPS PROTECTION ALGORITHMS 29 DEFAULT LATTITUDE
11 FRONT PANEL LEDS ENABLED 30 DEFAULT LONGITUDE
14 MAINTENANCE PORT INVERSE VIDEO 31 OBEY OXCO STATUS
15 MAINTENANCE PORT DEGREES SYMBOL 63 CARD 1 SUBNET MASK
16 TERMINAL CATEGORY 64 CARD 2 SUBNET MASK
20 CARD 1 IP ADDRESS 65 AIR/GROUND BEHAVIOUR
WHICH PARAMETER # <CTRL> N for next page ?
73 CP AUTO ATTACH 90 BGAN/SWIFT64 CONGESTION THRESHOLD
74 CC SBB CIPER PARAMETER 91 BGAN/SWIFT64 AUTO HANDOVER
83 IP HEADER COMPRESSION 95 OVER-POWER MARGIN
84 SW64 POSITION REPORTING 97 CHANNEL CARD CONFIGURATION
85 APAC TEST BEARER LONGITUDE 100 MIN SAT LOOK ANGLE
86 EMEA TEST BEARER LONGITUDE 101 PREEMPTABLE CALLS
87 AMERICAS TEST BEARER LONGITUDE 102 BGAN/SWIFT64 HYSTERESIS TIMEOUT
89 BGAN/SWIFT64 CONGESTION TIMEOUT 103 ANTENNA MOUNTING ANGLE (ROLL)
WHICH PARAMETER # <CTRL> N for next page ?
104 ANTENNA MOUNTING ANGLE (PITCH) 114 MAX ORDER FOR INTERMOD CHECK
105 ANTENNA MOUNTING ANGLE (ROTATION) 115 ENABLE PAP
106 RT-CHANNEL RESERVED POWER 116 PAP USER NAME
108 USWR ERROR THRESHOLD 117 PAP PASSWORD
109 IRS1 TYPE 118 VOICE PROCESSOR IP ADDRESS
110 IRS2 TYPE 119 LNA TO SDU RX THRESHOLD
113 MAXIMUM IGA POWER
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eN
fusion® HSD-440 Mark 2 Terminal
23-15-30 4-45
3 JUN 10
Figure 4-5 Menu 3 - Item M: Miscellaneous EEPROM Parameters
Table 4-9 Menu 3, Item M EEPROM Parameter Descriptions
Parameter
Numb
er
Parameter Name Description
1 HPA-to-antenna total
loss
Defines transmit coaxial cable loss from the HSD-440 Mark
2 Te
rminal at MPC1 to the antenna, including the DLNA
loss—maximum is 2.5 dB (includes DLNA loss of 0.8 dB).
2 Forward ID The Forward ID is not strapped, therefore you must enter
it using
this parameter.
3 GPS protection
alg
orithms
Disables the GPS algorithms the HSD-440 Mark 2
Terminal uses to prevent calls from interfering with the GPS
navigational system on the aircraft.
10 Number of channel
cards
Selects the number of channel cards for which the system
is
configured. Default is 2.
11 Front panel LEDs
en
abled
Future consideration is provided for additional LEDs,
beyond the two currently activated—default is 2.