User's Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion® HSD-440 Mark 2 Terminal
23-15-30 4-44
3 JUN 10
For more information about ORT parameters, see "Configuring the Owners
Requirements Table (ORT)" on page 6-1.
Figure 4-5 shows an example Menu 3, Item M: Miscellaneous EEPROM
parametersscreen display for the HSD-440 Mark 2 Terminal.
Table 4-9 describes the items available in Menu 3, Item M.
O: list ORT Displays all EEPROM parameters, including all cable losses and
LES/GES configurations.
I: set all LES id's Displays all ORT parameters to the same LES/GES access code and
service provider (including primary and secondary service providers).
Certain parameters are set using Menu 3, set CP ORT parameter.
K: set CP ORT parameter Use the ORT parameters to configure parameters for the HSD-440
Mark 2 Terminal.
T: write defaults to CP ORT Each SDU stores a copy of the User, Secure, and Manufacturer
Specific ORT parameter defaults in its software load.
V: bulletin board satellite
data
The HSD-440 Mark 2 Terminal stores the updated satellite longitude
from the bulletin board.
S: list event log Lists all events and system fault codes stored in non-volatile RAM.
When selected, several options are available:
• 0 displays the most recent saved entry.
• S displays next most recent entry saved.
• PERIOD displays all remaining logged entries.
• 1 displays special events (does not include ORR entries).
M: misc. EEPROM
parameter
Enables entry or entry changes to some of the EEPROM parameters
listed in function L.
G: clear call log Clears call log files for HSD-440 Mark 2 Terminal.
P: ocean region parameter Configures LES access codes (primary and secondary service
providers) for individual ORs.
H: list SCM/CP ORT Lists the values contained in both SCM and the CP ORT.
R: copy CP ORT to SCM Copies values stored in the CP ORT to the SCM. This may take
several minutes. To indicate progress, the HSD-440 Mark 2 Terminal
displays the number of bytes remaining to transfer.
U: clear SCM ORT Clear the ORT parameter from the SCM.
B: list channel card event log Lists the event log for individual channel cards.
Table 4-8 Menu 3 Item Descriptions (Continued)
Menu Item Description