User's Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion® HSD-440 Mark 2 Terminal
23-15-30 4-43
3 JUN 10
(c) Menu 3
Table 4-7Figure 4-4 shows the menu 3 screen display. Table 4-8 describes the
items available in Menu 3.
MENU 3 FIRMWARE Vx.x
L list EEPROM S list event log
C clear event log M misc. EEPROM parameter
F list call log G clear call log
O list ORT P ocean region parameter
I set all LES id's H list SCM/CP ORT
K set CP ORT parameter R copy CP ORT to SCM
T write defaults to CP ORT U clear SCM ORT
D output binary ORT V bulletin board satellite data
B list channel card event log
<CTRL> N next menu <CTRL> O previous menu = select reports
Figure 4-4 Menu 3 Screen Display
R: resume automatic
stee
ring
Re-activates programmed automatic antenna-steering in both azimuth
and elevation.
N: annotate log file Allows for input of text into a log file.
This feature can be used to document information suc
h as test conditions,
system or aircraft identification, or any pertinent information for later
review.
V: get firmware versions Displays the system Kernel and Application software versions, and the
cha
nnel card(s) and HPA firmware revisions.
S: set satellite longitude Sets the satellite longitude.
Table 4-7 Menu 2 Item Descriptions (Continued)
Me
nu Item Description
Table 4-8 Menu 3 Item Descriptions
Menu Item Description
L: list EEPROM Displays a list of all system
EEPROM parameters and their
corresponding values (this function is READ only).
Certain parameters are set using Menu 3, item M selection.
C: clear event log Clears all events stored in non-v
olatile RAM.
F: list call log Displays call log files for HSD-440 M
ark 2 Terminal. When selected,
three options are available:
• To display complete list of all log files
, press F.
• To list extended EIRP trace data, press X.
• To list all remaining entries, press PERIOD.