User's Manual

MENU 2 FIRMWARE Vx.x GND
A set veh-relative azimuth E set veh-relative elevation
K desired az veh-rel velocity R resume automatic steering
T enter time of day N annotate log file
L re-enter logon password V get firmware versions
Z reset 1252-A-3800-01 S set satellite longitude
G manual antenna steering
<CTRL> N next menu <CTRL> O previous menu = select reports
SYSTEM DESCRIPTION, INSTALLA
TION, AND MAINTENANCE MANUAL
eNfusion® HSD-440 Mark 2 Terminal
23-15-30 4-42
3 JUN 10
Figure 4-3 Menu 2 Screen Display
Table 4-7 Menu 2 Item Descriptions
Menu Item Description
NOTE: Menu 2 selections A and E are used to manually input navigational data to point the antenna
to a preferred satellite location and/or peak for maximum signal reception. These
commands are typically used where no IRS data is available.
A: set veh-relative
azimuth
Antenna azimuth pointing offset with r
eference to the front centerline of
the aircraft.
Offset value entered in degrees from 0
to 180, where a positive entry is
clockwise (cw) and a negative entry is counterclockwise (ccw).
K: desired az veh-rel
ve
locity
Activates continuous antenna azimuth sweep at a set elevation, as
entered with menu item E.
Azimuth sweep velocity entered as deg/sec value.
NOTE: When combined with a signal-monitoring reports selection,
sweep the antenna for maximum signal strength to determine
optimum location coordinates.
T: enter time of day Permits the entry of date and time for initial one-time setting of the Real
Time Clock.
L: re-enter logon
passwor
d
Permits a user to enter a new access level password: menu or maint.
Z: reset terminal Enables a complete, soft reset of the LRU; once reset, the menu access
pa
ssword must be re-entered.
G: manual antenna
s
teering
Set manual antenna-steering in both azimuth and elevation.
Four options:
• I increases elevation 0.5 deg
• M decreases elevation 0.5 deg
• L increases azimuth 0.5 deg
• J decreases azimuth 0.5 deg
E: set veh-relative
e
levation
Antenna elevation pointing offset with respect to the aircraft horizontal
rest position; i.e., assumed to have no pitch or roll offset.
Offset value entered in degrees from 0 to 90.