User's Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion® HSD-440 Mark 2 Terminal
23-15-30 4-41
3 JUN 10
Menu 1 Screen Display
Table 4-6 Menu 1 Item Descriptions
Menu Item Description
X: override forward
id/ICA
O address
Used in testing and fault isolation.
Enter a test or alternate FWD ID or ICAO ID
to use during fault isolation
procedures. Resetting the HSD-440 Mark 2 Terminal or cycling the power
cancels this function.
Y: explain error status Reports error status when failure LE
D is illuminated.
F: print equipment
st
ats
Prints a list of the current equipment statistics.
N: permit TFTP
so
ftware loads
Upgrade or load HSD software using the EMS serial data loader connected
to the HSD terminal maintenance port and using TFTP over the front panel
Ethernet port.
Note: When this option is enabled, software loads start within the next 10
minu
tes. To enable this option, the aircraft air/ground status must be
on-ground.
L: test LEDs Toggles the Power On (LED 1) and Fault (LED 2) LEDs on (A) and off (D)
o
r returns them to software control (X).
U: list event log Lists the current event log.
M: clear equipment
st
ats
Resets the equipment statistics. (See Item F.)
MENU 1 FIRMWARE Vx.x GND
X override forward id/ICAO address L test LEDs
Y explain error status U list event log (hex)
F print equipment stats M clear equipment stats
N permit TFTP software loads
<CTRL> N next menu <CTRL> O previous menu = select reports
(b) Menu 2
Figure 4-3 shows an example MPU Menu 2 screen display. Table 4-7 describes
the items available in Menu 2.