User's Guide

DRAFT
Page 2-2
17 Mar 2016
23-15-87
© Honeywell International Inc. Do not copy without express permission of Honeywell.
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
ARINC 781-500 SDU and SCM
• Customer information (address and contact information)
• Service provider details (obtained from your ISP)
• System and terminal information (terminal type, manufacturer, model number, serial number of
terminal)
• ICAO 24 bit technical address for Aero H+ services
• Aircraft information (tail number, fuselage/airframe number, manufacturer and model, and
country of registration)
• List of services required (for example, Aero H+ data-2, SBB PS, and SBB CS services)
• IMEI and IMSI for SBB services, printed on splash screen during boot-up while connected to
the maintenance port.
NOTE: IMSI is also printed on the SCM label.
NOTE: IMEIs are printed differently on the front panel maintenance port splash screen from
the SATCOM SWIFT CONFIG page on the TCP. The 14 digit IMEI appears in both
places. However, on the SATCOM SWIFT CONFIG page on the TCP, it has a 15th
digit appended to it. This digit is a check bit to validate the IMEI number.
2. Using the A781-500 System
This section describes how to perform the following tasks:
• Operating the TCP
• Logging On and Off
• Accepting and Making Calls in the Cockpit
• Accepting and Making Calls in the Cockpit
• Viewing BITE Information.
A. Operating the TCP
This section provides information about the TCP and its interfaces—output and input ports, the
screen, and the keyboard.screen and the keyboard.
(1) Screen
The TCP displays all data on the screen, as shown in Figure 2-1.
DRAFT as of
4 Mar 2016