User's Guide

DRAFT
Page 4-16
17 Mar 2016
23-15-87
© Honeywell International Inc. Do not copy without express permission of Honeywell.
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
ARINC 781-500 SDU and SCM
Figure 4-8. SATCOM USIM/DATA Menu
Table 4-16 describes the information available on the USIM/Data menu.
Table 4-16 SATCOM USIM/DATA Menu
Label Description
USIM#1 Reports the status of USIM#1 bus as OK, WARMING, SBB LOG, FAULT, or N/A
if channel card 1 is not in SBB mode.
If status is FAULT, check that SIM card is not damaged and is properly inserted.
Power cycle after checking.
USIM#2 Reports the status of USIM#2 bus as N/A.
If status is FAULT, check that SIM card is not damaged and is properly inserted.
Power cycle after checking.
USIM#3 Reports the status of USIM#3 bus as N/A.
If status is FAULT, check that SIM card is not damaged and is properly inserted.
Power cycle after checking.
USIM#4 Reports the status of USIM#4 bus as N/A. If status is FAULT, check that SIM card
is not damaged and is properly inserted. Power cycle after checking.
ETH#1 Reports the status of ETH#1 bus as DISABLED, LINK, or NO LINK.
ETH#2 Reports the status of ETH#2 bus as DISABLED, LINK, or NO LINK.
QUAD ETH#3 Reports the status of QUAD ETH#3 bus as DISABLED, LINK, or NO LINK.
QUAD ETH#4 Reports the status of QUAD ETH#4 bus as DISABLED, LINK, or NO LINK.
ETH#5 Reports the status of ETH#5 bus as DISABLED, LINK, or NO LINK.
NOTE: Only Ethernet 3 is fully supported. Ethernet 1, 2, and 5 are not supported and Ethernet 4
is only used for application data loading.
1 5 10 15 20 24
1
SATCOM USIM/DA
T
A
USIM#1 ETH#2
1L
3
OK D I SABLED
3
1R
US I M# 4 QUA D ETH # 3
2L
5
N/A L INK
5
2R
ETH# 1 QUA D ETH # 4
3L
7
D I SABLED D I SABLED
7
3R
ETH#5
4L
9
<RETURN DISABLED
9
4R
DRAFT as of
4 Mar 2016