User's Manual
Table Of Contents
- Customer Response Form
- Record of Revisions
- Service Bulletin List
- List of Effective Pages
- Introduction
- System Description
- System Operation
- 1. Registering and Activating Terminals
- 2. Using the A781-200 System
- 3. Channel Status and System Configuration
- 4. Maintenance Mode
- Installation
- Test and Fault Isolation
- Maintenance and Repair
- Appendix A: Return Material Authorization
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
ARINC 781-200 SDU and SCM
23-15-30 2-26
DATE TBD
B. Viewing BITE Information
The BITE information available in maintenance mo
de is the same as the BITE information
available in In-Flight mode. For information about the BITE menus, see "Viewing BITE
Information" on page 2-15.
C. Starting the Intermod Test
For information and instructions about running the PIM test, see "Passive Intermodulation
(PIM) Test" on page 3-8.
D. Viewing Configuration
The configuration menus available in maintenance mode are the same as the
con
figuration menus in In-Flight mode. For information about these menus, see "System
Part Numbers" on page 2-21.
E. Viewing SATCOM Parameters
As shown in Figure 2-10, the SATCOM PARMS menu provides information about logon,
failover, and the channel cards.