Specifications

6 EMPYRE ELITE INSTALLATION AND OPERATION MANUAL • 2011
SAFETY
Safety Alert Symbol
The Safety Alert Symbol identies
important safety messages in the manual
and on the furnace. When this symbol is
present,bealerttothepossibilityofinjury
or death. Follow all instructions in the safety message
given. This symbol means attention, be alert, and your
safety is involved.
Why is SAFETY important to you? Three very important
reasons:
1. Accidents disable and can be fatal.
2. Accidents cost.
3. Accidents can be avoided.
Signal Words
Note the use of the signal words: DANGER, WARNING
and CAUTION with the safety messages.
The appropriate signal word has been selected using
the following guidelines:
DANGER
DANGER: Indicates an imminently hazardous situation
that, if not avoided, WILL result in death or serious
injuryifproperprecautionsarenottaken.
WARNING
WARNING: Indicates a potentially hazardous situation
that, if not avoided, COULD result in death or serious
injuryifproperprecautionsarenottaken.
CAUTION
CAUTION: Indicates a potentially hazardous situation
that, if not avoided, MAY result in minor or moderate
injuryifproperpracticesarenottaken,orservesasa
reminder to follow appropriate safety practices.
Safety Decals
Please read and follow directions to ensure safe
practices when using the Empyre Elite furnace.
1) DANGER/WARNING/CAUTION
Safety Instructions: Located on the front right
corner below controls.
2) FURNACE SERIAL DECAL – Located on the right
side front.
3) ELECTRICAL/INSTALLATION:
Located on top right of the side panel.
4) CAUTION: Lid area may be very hot. Switch blower
off before opening. Located right of centre back
uecleanoutcover.
5) WARNING: ELECTROCUTION HAZARD. Always
secure door with latch. Tighten with wrench.
Located on centre of rear access cover.
6. ELECTRICAL WIRING DIAGRAM - Located inside
rear access cover.
7) SPECIFICATIONS – Located on the upper left corner
on the side panel of the furnace.
Canadian CSA Requirements
Installation of the Empyre Elite as an add-on unit in
the Canadian provinces and territories must comply
with requirements of CAN/CSA-B365, and changes
to the installation must comply with the following CSA
requirements:
CSAB139-foroil-red
CSA C22.1 - for electric
CAN/CGA-B149.1orCAN/CGA-B149.2-forgas-red