Owner`s manual

30816-3-0113Page 8
SPECIFICATIONS
Model VFD26F(M,P)(3,7) VFD26F(M,P)2 VFD26FP(3,7)0L10
InputMaximum 20,000 20,000 10,000
Minimum 14,000 14,000 N/A
NAT
Orice 2.10 mm (P-288) #49 (.073") P-265 #53 (.0595") P-214
Air Shutter Opening 1/8" 1/8" 1/8"
LP
Orice #55 (.052") P-182 #55 (.052") P-182 #64 (.036") P-193
Air Shutter Opening 1/4" 1/4" 1/4"
Fireplace Dimensions
Height 30 1/4" 30 1/4" 30 1/4"
Depth 13 1/8" 13 1/8" 13 1/8"
Front Width 30" 30" 30"
Rear Width 25" 25" 25"
Gas Inlet 3/8" 3/8" 3/8"
Accessories
FBBX BlowerExtensionKit(MUSTorderFBB4)
FBB4 Automatic Blower (MUST order FBBX)
VPS26HP Bottom Trim Kit
VF2H26HP Hammered Pewter Hood Kit
VPF26HP Hammered Pewter Trim Kit
FPP26E BrickLiner
VPL26HP Hammered Pewter Slat Louver
Accessories for Millivolt VFD26F(M,P)(3,7) Only
FRBC Battery Operated Remote Control
FRBTC Battery Operated Remote Control w/Thermostat
FREC Electric Remote Control
FWS-1 Wall Switch
TMV Wall Thermostat, Millivolt - Reed Switch
TRW Wireless Remote Wall Thermostat
Watervaporisaby-productofgascombustion.Anunventedroom
heaterproducesapproximatelyoneounce(30ml)ofwaterforevery
1,000BTU's(.3KW's)ofgasinputperhour..
Unvented room heaters are recommended as supplemental heat (a
room) rather than a primary heat source (an entire house). In most
supplemental heat applications, the water vapor does not create a
problem.Inmostapplications,thewatervaporenhancesthelow
humidityatmosphereexperiencedduringcoldweather.
The following steps will help insure that water vapor does not
becomeaproblem.
1. Be sure the heater is sized properly for the application, including
amplecombustionairandcirculationair.
2. Ifhighhumidityisexperienced,adehumidiermaybeusedto
help lower the water vapor content of the air.
3. Do not use an unvented room heater as the primary heat source.
WATER VAPOR: A BY-PRODUCT OF UNVENTED ROOM HEATERS