Owner`s manual

30816-3-0113 Page 33
CAUTION: ALL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRICIAN AND SHALL BE IN COMPLIANCE WITH ALL LO-
CAL, CITY AND STATE BUILDING CODES. BEFORE MAKING THE ELECTRICAL CONNECTION, MAKE SURE THAT MAIN POWER
SUPPLY IS DISCONNECTED. THE APPLIANCE, WHEN INSTALLED, MUST BE ELECTRICALLY GROUNDED IN ACCORDANCE
WITH LOCAL CODES OR, IN THE ABSENCE OF LOCAL CODES, WITH THE NATIONAL ELECTRICAL CODE ANSI/NFPA 70 (LAT-
EST EDITION).
Afactoryinstalledjunctionboxislocatedonthelowerrightsideofthereplace.Wiringmustbefedtothejunctionboxandattachedto
thereceptaclethatisprovided.Leaveapproximately6"ofwireinthejunctionboxforconnection.
Attachblackwiretohotside(brassscrews)ofthereceptacleandwhitewiretooppositeside(silverscrews)ofreceptacle.Theground
wireshouldbeattachedtothegreen(ground)screw.
Installthereceptacleintothejunctionbox.Attachcoverplate.
JUNCTION BOX WIRING INSTALLATION INSTRUCTIONS
Figure 26
Junction Box Connections