Owner`s manual

30816-3-0113Page 28
IP ELECTRONIC SYSTEM OPERATING INSTRUCTIONS
5.25 VDC ELECTRONIC CONTROL VALVE
Theelectroniccontrolvalvesystemincludestheabilitytoswitch
the pilot from a standing pilot mode to an intermittent pilot mode.
• IPI Mode - In the Intermittent Pilot mode, when the unit is
turnedON,itwillcausesparktothepilot,lightthepilot,
thenallowtheburnertolight.Whentheunitisturnedto
OFF,boththeburnerandpilotwillbeOFF.
• CPI Mode - In the Continuous Pilot mode, the pilot re-
mainsONcontinuouslyevenwhentheburneristurned
OFF.
Note:Asmalltoggleswitchislocatedonabracketthatisusedto
switch from IPI (upward position) to the CPI (downward position).
See Figure 25.
When the unit is turned to ON, the electrical current will energize
asparktothepilotigniter.Oncethepilotsensorheatsup(aftera
fewseconds),thevalvewillbeenergized,allowinggastoowto
theburner.
1. Follow the SAFETY and LIGHTING INSTRUCTIONS for In-
termittent Pilot controls found inthis manual,and onlabels
found in the control compartment located in the lower cavity
of the appliance.
2. During the operating season (or in power outage periods), it is
recommended that the pilot remain in the CPI (standing pilot
mode) to reduce cold start issues, and/or conserve battery
backuppowerduringapoweroutage.
3. The gas valve has inlet and outlet pressure taps as shown in
Figure25.Refertopage11forgaspressurerequirements.
Note: Thegas control has a manualHI/LO ame adjustment
knob(regulator)thatallowsyoutoincreaseordecrease
theheightoftheburner ame. SeeFigure25.Rotate
theHI/LOknobcounterclockwiseto“HI”toincreasethe
ameheight,andclockwiseto“LO”todecreasetheame
height.
OPTIONAL REMOTE CONTROLS
Optionalremotecontrolsareavailableforusewiththisappliance.
Toconnecttheremotereceivertotheappliance,rstdisconnect
the ON/OFF switch wires from the white and green wire connec-
tors and connect the wires from the remote receiver to the green
and white wire connectors. See Figure 25.
Follow the instructions included with the remote control for pro-
gramming and other operational information.
Figure 25
DFC
ELECTRONIC
CONTROL
MODULE
REMOTE
CONTROL
RECEIVER
AA (4)
BATTERY
BACKUP
IPI
CPI
PILOT SELECTOR SWITCH
IPI - INTERMITANT PILOT (UP)
CPI - CONTINUOUS PILOT (DOWN)
SPARK ROD
GROUND
9 PIN CONNECTOR
PILOT
SENSOR
GAS VALVE
OUTLET
PRESSURE
TAP
INLET
PRESSURE
TAP
IGNITOR
SENSOR
PILOT
ASSEMBLY