Owner`s manual

30816-3-0113Page 22
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING:
result, causing property damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted by
hand. When lighting the pilot, follow these instructions
exactly.
B. BEFORE LIGHTING smell all around the appliance area


WHAT TO DO IF YOU SMELL GAS
 
 
Do not use any phone in your building.
 
phone. Follow the gas supplier's instructions.
 
department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in

service technician. Force or attempted repair may

D. Do not use this appliance if any part has been under

to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
3. Pushingascontrolknobslightlyandturnclock-
wise to "OFF". Do not force.
TO TURN OFF GAS TO APPLIANCE
1. Setthermostat(gascontrolknob)tolowestsetting.
2. Turn off all electric power to appliance if service is to
beperformed(ifapplicable).
LIGHTING INSTRUCTIONS
 7. Turn gas control knob counterclockwise  to
"PILOT."
 8. Pushingascontrolknoballthewayandholdin.Repeat-
edlypushthepiezoignitorbuttonuntilpilotislit(oruse
amatchtolightpilot).Continuetoholdthecontrolknob
inforaboutoneminuteafterthepilotislit.Releaseknob
anditwillpopbackup.Pilotshouldremainlit.Ifitgoes
out, repeat steps 4 through 8.
• If knob does not pop up when released, stop and
immediately call your service technician or gas sup-
plier.
• Ifthepilotwillnotstaylitafterseveraltries,turnthe
gascontrolknobto"OFF"andcallyourservicetechni-
cian or gas supplier.
 9. Turngascontrolknobcounterclockwise
to "HI"
(5).
 10. Turnonallelectricpowertoappliance(ifapplicable).
 11. Setthermostat(gascontrolknob)todesiredsettingfrom
"HI" (5) to "LO" (1).
1. STOP!Readthesafetyinformationabove.
 2. Setthermostat(gascontrolknob)tolowestsetting.
 3. Turnoffallelectricpowertotheappliance(ifapplicable).
 4. Pushingascontrolknobslightlyandturnclockwise
to "OFF". Do not force.
5. Wait ten minutes to clear out any gas. Then smell for gas,
includingneartheoor.Ifyousmellgas,STOP!Follow"B"
inthesafetyinformationabove.Ifyoudon'tsmellgas,go
tothenextstep.
 6. Findpilot-Followmetaltubefromgascontrol.Thepilotis
locatednexttotheburner,neartherightside.
HYDRAULIC THERMOSTAT LIGHTING INSTRUCTIONS
PIEZO IGNITOR