Owner`s manual
30816-3-0113 Page 19
WARNING:
result, causing property damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted by
hand. When lighting the pilot, follow these instructions
exactly.
B. BEFORE LIGHTING, smell all around the appliance area
WHAT TO DO IF YOU SMELL GAS
phone in your building
phone. Follow the gas supplier's instructions.
department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
or explosion.
D. Do not use this appliance if any part has been under water.
the appliance and to replace any part of the control system
and any gas control which has been under water.
1. Openbottomlouverassembly(ifapplicable).
2. Set REMOTE/OFF/ON switch to "OFF."
3. Turnoffallelectricpowertotheapplianceifserviceistobe
performed(ifapplicable).
4. Pushingascontrolknobslightlyandturnclockwise
to "OFF". Do not force.
5. Closebottomlouverassembly(ifapplicable).
1. STOP!Readthesafetyinformationaboveonthispage.
2. Openbottomlouverassembly(ifapplicable).
3. Set REMOTE/OFF/ON switch to
"OFF".
4. Turn off all electric power to the
appliance(ifapplicable).
5. Pushingascontrolknobslightly
andturnclockwise
to "OFF".
NOTE:Knobcannotbeturnedfrom"PILOT"
to "OFF" unless knob is pushed in slightly.
Do not force.
6. Wait ten minutes to clear out any gas. Then
smell for gas, including near the
oor.Ifyousmellgas,STOP!Fol-
low "B" in the safety information
above.Ifyoudonotsmellgas,go
tothenextstep.
7. Findpilot-Followmetaltubefrom
gas control. The pilot is located
next tothe burner, near the right
side.
8. Turn gas control knob counterclockwise
to "PILOT".
9. Pushincontrolknoballthewayandholdin.Repeatedlypush
the Piezo Ignitor Button until the pilot is lit. Continue to hold
thecontrolknobinforaboutoneminuteafterthepilotislit.
Releaseknob,anditwillpopbackup.Pilotshouldremainlit.
If it goes out, repeat steps 5 through 9.
• Ifknobdoesnotpopupwhenreleased,STOPandIM-
MEDIATELY call a qualied service technician or gas
supplier.
• Ifthepilotwillnotstaylitafterseveraltries,turnthegas
controlknobto"OFF"andcallyourservicetechnicianor
gas supplier.
10. Turngascontrolknobcounterclockwise to "ON".
11. Set REMOTE/OFF/ON switch to desired setting.
12. Turnonallelectricpowertotheappliance(ifapplicable).
13. Closebottomlouverassembly(ifapplicable).
GAS CONTROL KNOB
SHOWN IN "OFF" POSITION.
THERMOCOUPLE
(NATURAL)
ELECTRODE
PILOT
THERMOPILE
REMOTE
OFF
ON
THERMOCOUPLE
(LPG)
GAS CONTROL KNOB
SHOWN IN "OFF" POSITION.
THERMOCOUPLE
(NATURAL)
ELECTRODE
PILOT
THERMOPILE
REMOTE
OFF
ON
THERMOCOUPLE
(LPG)
10,000 BTU MILLIVOLT LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE










