Owner's Manual

8
Optional Soft-Shot Bolt
You will notice that your Vanquish comes with 2 different Bolts. One Bolt is installed on your
marker and the other was shipped as a separate component. The red anodized Bolt (not
installed in the marker) is called the Soft-Shot Bolt. This Bolt is designed so that while in
the firing cycle, the air is restricted from venting, so that when the Bolt returns, it hits an air
cushion. This creates a softer shot, but at the expense of a lower cycling speed and fewer
balls-per-second (approx. 13.5 bps). Please note that due to the restrictions of most tourna-
ments, playing with this lower cycle rate is not a concern and some players prefer the softer
feeling shot. To insure complete satisfaction with the Vanquish in any playing condition, we
offer you both Bolts.
See the GENERAL MAINTENANCE section for installation instructions
Pressure and Velocity Adjustment
The velocity can be adjusted by adjusting the pressure. Locate the Pressure Adjustment
Screw and using the 3/32” Hex wrench, turn the screw clockwise (inward) to increase the
pressure (and velocity). Turn the screw counter-clockwise to decrease the pressure.
Turn on the Vanquish and enter the LIVE mode on the display (see below for more detail).
Press and hold the D-pad to the Left or Right for 1 second at a time to change displayed infor-
mation. Repeat this process until the display cycles to pressure reading. This visual indicator
will help determine the correct pressure/velocity you desire.
Trigger Adjustment
There are four adjustments that can be made on the on the trigger. Use the 3/32” hex wrench
to make any desired adjustments:
A. Magnetic Tension – this affects how “hard” the pull of the trigger is
- Turning the adjustment screws “in” or clockwise will increase the force needed to
pull the trigger
B. Forward Travel – This adjusts the position of the trigger when not being fired
- Turning the adjustment screws “in” or clockwise will decrease the trigger length
of travel
C. Stop – This adjusts the farthest position the trigger will travel when depressed
- Turning the adjustment screws “in” or clockwise will decrease the travel of the
trigger by having the trigger stop sooner
D. Activation Point – This adjusts the position where the trigger pull registers a shot
- Turning the adjustment screws “in” or clockwise will decrease the travel of the
trigger needed before the Vanquish registers a shot