Owner's Manual

6
Vanquish Power On/Off
• Turn Marker ON - Press and hold the CENTER of the Directional
Pad (the black button/joy stick located under the screen) until
the screen illuminates to turn the board/marker ON. The Boot
Up Splash Screen will display for 3 seconds. You are now in
LIVE Mode (see below for more details) and the marker is ready
to fire.
• Turn Marker OFF - Press and hold CENTER on Directional Pad
(D-pad) to enter the MAIN Menu, release D-Pad and then press
CENTER on D-Pad when the display reads OFF to turn board off.
• Automatic Off feature - The Empire Vanquish also has an
automatic off feature. If you accidentally leave your marker
powered up, it will shut itself off after approximately 10 minutes
of inactivity.
Note: the Auto Off time and the Boot Screen Display are adjustable in the SYSTEM Menu
Tank Installation
The Empire Vanquish is designed to work with compressed air/nitrogen only. Do not use
CO
2
, as it will damage your marker. The Empire Vanquish utilizes a fully functional regula-
tor at the bottom of the grip frame that doubles as an On/Off ASA (Air Source Adapter) or
receiver for a standard threaded preset output compressed air system. If you are using an
adjustable output regulator system, the output pressure should be 500-650 psi.
WARNING
• Remember compressed air or nitrogen systems can be extremely dangerous if misused or
improperly handled. Use only cylinders meeting D.O.T., TC or regionally defined specifica-
tions.
• Never add any lubricants or greases into the fill adapter on your tank regulator.
• Do not install compressed air or load paintballs into your Empire Vanquish until you feel
completely confident with your ability to handle your Empire Vanquish safely.
BEFORE PRESSURIZING YOUR EMPIRE VANQUISH
• Check to make sure that you and anyone within range are wearing eye protection designed
specifically for paintball.
• Double check that all screws are tightened and no parts are loose before installing your
tank.
• Make sure the Firing Engine system is properly locked in place.
• Ensure you have a barrel plug, barrel sock, or other specifically designed barrel blocking
device in place.
• Make sure there are no paintballs in the marker and the power is off.
PRESSURIZING YOUR EMPIRE VANQUISH
• Flip the regulator’s On/Off ASA lever forward so it’s pointing toward the front of the marker.
• Install a compressed air tank, by screwing it in clockwise; making sure it’s fully threaded
into the ASA.
• Flip the On/Off ASA lever back so it’s flush with the regulator and pointing toward the rear
of the marker. The marker will become pressurized.