Owner's Manual

5. Once open, you can access the Main Board and the USB port for PC connection.

Trigger Maintenance

The Trigger is removed from the Frame Insert using a single pin located on the side of the Grip

Frame (see image below).

1. Split the body of the Vanquish Engine as explained earlier on page 26.

2. Using the 3/32” Hex wrench, remove the two screws to free the Frame Insert.

3. Unplug the Battery Harness from the Board

4. Use a hex wrench to push the pin out of the Frame Insert, which frees the Trigger

5. Once the Trigger is free, inspect for any paint or debris and clean with a cloth dampened

with water.

6. The Spring Tension can be adjusted with the Trigger removed.

7. If necessary, clean the bearings to ensure a smooth trigger pull. The bearings can be

lubricated with a drop or two of marker oil on the side housing.

8. To re-install, place the trigger back in the Frame Insert, secure with the Trigger Pin and

place the Frame Insert into the Grip Frame and secure the screws with a 3/32” hex wrench.

• Carefully remove the Eye Board from the body

• Use a Q-tip to remove any paint or debris from the Eye Board and the Eye cavity of the

Body

• Ensure that the opening in front of the Eyes is clear and that the laser has a clear path to

the opposite Eye.

• Inspect the Ball Detents, faulty or worn out Ball Detents can cause double feeding or ball

breaks

• Clean or replace as necessary

• Re-install the Eye Board and Eye Cover. Repeat process with the opposite Eye Boards if

necessary

Regulator

Removal of Regulator

• Remove the two regulator mount screws located on the bottom of the grip frame with a

3/32” Allen wrench by turning them counter-clockwise.

• Make sure the O-Ring is on the bottom of the air tube; grease if necessary.

• Slide regulator back into the grip frame and tighten the regulator mount screws with a

3/32” Allen wrench.

Installation of Regulator Assembly

• Make sure the air transfer O-Ring is on the bottom of the grip frame; grease if

necessary.

• Slide regulator back into the grip frame and tighten the regulator mount

screws with a 3/32” Allen wrench.

Warning: Do not take the regulator apart; it is not designed to be user serviceable. Damage to the

regulator will not be covered under warranty.

Splitting the Body

1. Remove the Firing Engine assembly from the Body (see pg 23)

2. Locate the screw that holds the Body to the Grip Frame, it is located at the front of the

marker, within the Front Grip below where the Barrel meets the Body.

3. Using the 3/32” Hex wrench, completely loosen the screw holding the Body to the Grip

Frame.

4. The Body can now be opened away from the Grip Frame hinging at the back of the marker.