Owner's Manual

9. Apply grease to the two small O-Rings on the Rod #8a, #8b.

10. Lubricate the 3 inner O-Rings on the Air Guide (#2a, #2b, #2c), no lube is needed on the

outer O-Rings.

11. Apply a light coat of grease on the inner surface of the Air Guide, where the Bolt O-Rings

make contact.

12. Reassemble the Firing Engine in the reverse order of Step 3 thru 1.

Firing Engine O-Ring Guide

1 Air Guide O-ring - UR 020/70 (72558) 6 Bolt O-ring - BUNA 015/90 (72549)

2 Air Guide (Internal) O-ring - UR 017/70 (72556) 7 Bolt O-ring - UR 016/70 (72555)

3 Back Cap O-ring - BUNA 019/70 (72557) 8 Rod O-ring - UR 013/70 (72552)

4 Back Cap O-ring - UR 020/70 (72558) 9 Rod O-ring - UR 014/20 (72553)

5 Back Cap (Internal) O-ring - UR 017/70 (72556) 10 Rod O-ring - BUNA 015/70 (72554)

Cleaning the Eyes / Ball Detents

The eyes should be cleaned thoroughly after a ball break. Leaving paint on the eyes for an

extended amount of time may cause damage to the electrical contacts. Remove the eye cover

to access the eye board. Use a cotton swab to remove paint or debris in the body and off of

the eye board. Ensure that the path in front of the eyes is clear and reinstall the eye boards

and eye covers.

The Eyes should be cleaned thoroughly after a ball break in the breech. Leaving paint on

the Eyes for an extended amount of time can damage the electrical contacts and cause a

malfunction.

• Remove the Eye Cover using the 3/32” Hex wrench to access the Eye Board