Owner's Manual

22
How to Sync Settings with Vanquish Marker
Click “Sync Settings” to sync the setting on the Tool software with the
connected Vanquish marker. The settings must be synced before the
changed settings appear on the Vanquish marker. The Status bar and
pop-up messages will notify users when the sync is complete. Syncing
the settings usually takes around five seconds.
How to Save Settings to PC
Click Save Settings and follow the prompt to save the current settings from
the Vanquish USB Tool. Configuration 1, 2, 3 and System settings will be
saved on the PC. The file format is .txt so it may be edited outside of the
Vanquish USB Tool.
How to Load Settings from PC
Click “Load Settings” and follow the prompt to open and
load a Vanquish settings file into the Vanquish USB Tool
software. Click “Sync Settings” to sync the loaded set-
tings with the Vanquish. Settings files are in .txt format,
so they can also be edited outside of the Vanquish USB
Tool.
How to Update the Vanquish Board Software
Clicking “Update Software’ will open a prompt that allows the user to select
a Vanquish Firmware File (.vff). When the file is selected the software will
be downloaded onto the Vanquish. The Status Bar and popup messages
will notify users when the update is complete. This process typically takes
between 30-45 seconds.
How to Download Custom Boot Screens to Vanquish
Click “Download Custom Boot Screen” and follow the prompt to
choose a Vanquish Boot Screen File (.vbs) from the PC. Vanquish
Boot Screen files are created with the Vanquish Boot Screen Editor
(see below). When the file is selected the custom boot screen will be
downloaded onto the Vanquish. The Status Bar and popup messages will notify users when
the download is complete. The download typically takes about 5 seconds.
To Disconnect the Vanquish from the PC
Select PROGRAM->DISCONNECT to stop communication between marker and PC.