Owner's Manual

21
drivers. Proceed as before with steps 2-5 to install.
Windows Vista Manual Install:
1. After connecting the Vanquish to the USB port the New Hardware Found window will ap-
pear.
2. Select “Locate and install driver software (recommended)”.
3. When windows asks for the disk select “I don’t have the disc, Show me other options”.
4. Windows will say it could not find driver software. Click “Browse my computer for driver
software”.
5. Browse to the USB Driver Folder in the Vanquish PC Software Folder. Windows should
install the first driver.
6. After installing the first driver the New Hardware Found Window should pop up again to
install the second driver. Repeat steps 2-5 to install the second driver.
Windows 7 Manual Install:
1. With Vanquish connected to USB Port go to Start > Control Panel.
2. Select “Hardware and Sound”.
3. At the next screen select “Device Manager” under “Devices and Printers”.
4. In the Device Manager window under “Other Devices” there should be a device with a
name similar to “FT232…” with a yellow warning symbol next to it, indicating the driver is
not installed. Right-click this to bring up a small menu.
5. Select “Update Driver Software”.
6. Next select “Browse my computer for driver software”.
7. Browse to the USB Driver folder in the Vanquish PC Software Folder. This should install
“USB Serial Converter” which is the first driver.
8. To install the second driver repeat steps 4-6. This should install USB Serial Port.
Finish Installation
Open the Vanquish USB Tool application (Vanquish USB Tool.exe) and the Vanquish Marker
should automatically connect to the USB Tool. The status bar in the bottom of the window
will indicate that the Vanquish has been connected.
Using the Vanquish USB Tool Software
The Vanquish USB tool allows users to complete the following tasks: edit and sync settings
with the Vanquish, save settings to the PC, download custom boot screens onto the Vanquish,
and update the Vanquish software.
1. Assure all paintballs and the gas source is removed from marker and marker has been
safely discharged before connecting marker to your PC.
2. Remove bolt system and remove front grip frame screw to expose mini USB port on under
side of the main circuit board (see page 26).
3. Connect USB cable between marker and PC.
4. Open the Vanquish USB Tool program and the marker will automatically connect to the
Vanquish USB Tool.
5. If the Vanquish USB Tool software program is already open, press Connect.
ONCE CONNECTED:
Once the Vanquish is successfully connected to your PC, the User Configurations and System
Settings will be loaded from the Vanquish board and automatically shown in the Vanquish
USB Tool.
Users have the ability to:
-Change settings and load them to the marker
-Load settings from a file on the PC and load them onto the marker
-Save currently displayed settings onto the PC
-Flash new software onto the Vanquish
-Load Custom Boot Up Screens onto the Vanquish