Owner's Manual

16
manual.
Note – if a custom boot screen has not been downloaded but the user turns it on the default
boot screen will display. The firmware version will not display when the custom boot screen
is turned on.
• The screen displays whether the Custom Boot setting is On or Off
• Press RIGHT or Press CENTER of D-Pad to change the Custom Boot setting (default is
OFF)
• Press UP or DOWN to switch the setting to either ON or OFF
• Press LEFT or Press CENTER of D-Pad to save setting and return to SYSTEM menu
Boot Time – This setting changes the amount of time the boot up
splash screen is displayed when the marker is turned on. This time
is adjustable from 0-5seconds with a setting of 0 not displaying the
splash screen at all. This setting applies to both the standard and
custom boot screens.
• The screen displays the current Boot Time setting (in seconds)
• Press RIGHT or Press CENTER of D-Pad to change the Boot
Time setting (default is 3 sec)
• Press UP or DOWN to increase/decrease the setting (0-5 sec)
• Press LEFT or Press CENTER of D-Pad to save setting and
return to SYSTEM menu
PRES SIZE – There are two font size options for displaying the
Regulator Pressure – Large or Small.
• The screen displays whether the PRES SIZE setting is Large or
Small
• Press RIGHT or Press CENTER of D-Pad to change the Pres Size
setting (default is Small)
• Press UP or DOWN to switch the setting to either SMALL or LARGE
• Press LEFT or Press CENTER of D-Pad to save setting and return to SYSTEM
menu
System (SYS) Sound - Turns the system sounds ON or OFF, including the
startup, shutdown, and enter/exit menu sounds.
• The screen displays the current setting of either ON or OFF
• Press RIGHT or Press CENTER of D-Pad to change the System Sound
(default is ON)
• Press UP or DOWN to cycle through ON or OFF
• Press LEFT or Press CENTER of D-Pad to save setting and return to SYSTEM
Menu
JSTK Sounds - Joystick Sounds: Enables a beep when the joystick
is activated when setting is ON.
• The screen displays the current setting of either ON or OFF
• Press RIGHT or Press CENTER of D-Pad to change the Joy
stick Sound setting (default is ON)
• Press UP or DOWN to cycle through ON or OFF
• Press LEFT or Press CENTER of D-Pad to save setting and return
to SYSTEM Menu
Lube Alert - This setting turns the Slick Assistant lube alerts ON or
OFF. The Slick Assistant lubrication monitoring system will alert the
user if it is time to re-lube the marker. This alert plays a sound and
shows a special alert message on screen when the marker is turned on. It also plays a sound
if the Slick Assistant Lube Gauge is displayed during live mode.
• The screen displays the current setting of either ON or OFF
• Press RIGHT or Press CENTER of D-Pad to change the Lube Alert setting (default is ON)
• Press UP or DOWN to cycle through ON or OFF
• Press LEFT or Press CENTER of D-Pad to save setting and return
to SYSTEM Menu
Reset Lube - This setting will reset the lube gauge. This should be
reset each time the marker is lubed. Two choices reset or cancel
Training - When training mode is ON, while in Live Mode, instead of
the marker cycling the solenoid, it will chirp quickly. The eyes are
bypassed. This is for users to practice trigger activation without the
need for an air source. Note – the marker will not fire while training
mode is on.
• Press RIGHT or Press CENTER of D-Pad to see if Training Mode
setting is On or OFF
• Press UP or DOWN to cycle through ON or OFF (default is OFF)
• Press LEFT or Press CENTER of D-Pad to save setting and return to SYSTEM
Menu