Troubleshooting Guide

26
3/32” Allen wrench by turning them counter-clockwise.
• Make sure the O-Ring is on the bottom of the air tube; grease if necessary.
• Slide regulator back into the grip frame and tighten the regulator mount screws with a
3/32” Allen wrench.
Installation of Regulator Assembly
• Make sure the air transfer O-Ring is on the bottom of the grip frame; grease if
necessary.
• Slide regulator back into the grip frame and tighten the regulator mount
screws with a 3/32” Allen wrench.
Warning: Do not take the regulator apart; it is not designed to be user serviceable. Damage to
the regulator will not be covered under warranty.
Splitting the Body
1. Remove the Firing Engine assembly from the Body (see pg x)
2. Locate the screw that holds the Body to the Grip Frame, it is located at the front of the
marker, within the Front Grip below where the Barrel meets the Body.
3. Using the 3/32” Hex wrench, completely loosen the screw holding the Body to the Grip
Frame.
4. The Body can now be opened away from the Grip Frame hinging at the back of the marker.
5. Once open, you can access the Main Board and the USB port for PC connection.
• Carefully remove the Eye Board from the body
• Use a Q-tip to remove any paint or debris from the Eye Board and the Eye cavity of the
Body
• Ensure that the opening in front of the Eyes is clear and that the laser has a clear path to
the opposite Eye.
• Inspect the Ball Detents, faulty or worn out Ball Detents can cause double feeding or ball
breaks
• Clean or replace as necessary
• Re-install the Eye Board and Eye Cover. Repeat process with the opposite Eye Boards if
necessary
Trigger Maintenance
The Trigger is removed using a single screw located on the side of the Grip Frame (see image
below). Using the 3/32” Hex wrench, remove the screw to free the Trigger. Once the Trigger
is free, inspect for any paint or debris and clean with a cloth dampened with water. The
Spring Tension can be adjusted with the Trigger removed. If necessary, clean the bearings
to ensure a smooth trigger pull. The bearings can be lubricated with a drop or two of marker
oil on the side housing. To re-install, place the trigger back in the Grip frame and replace the
Trigger Retention screw.
Regulator
Removal of Regulator
• Remove the two regulator mount screws located on the bottom of the grip frame with a
