Troubleshooting Guide

ManualsBrandsEmpire ManualsPaintballVanquish v1.5

when the custom boot screen is turned on.

• The screen displays whether the Custom Boot setting is On or Off

• Press RIGHT or Press CENTER of D-Pad to change the Custom Boot setting (default is

OFF)

• Press UP or DOWN to switch the setting to either ON or OFF

• Press LEFT or Press CENTER of D-Pad to save setting and return to SYSTEM menu

Boot Time – This setting changes the amount of time the boot up splash screen is displayed

when the marker is turned on. This time is adjustable from 0-5seconds with a setting of 0 not

displaying the splash screen at all. This setting applies to both the

standard and custom boot screens.

• The screen displays the current Boot Time setting (in seconds)

• Press RIGHT or Press CENTER of D-Pad to change the Boot

Time setting (default is 3 sec)

• Press UP or DOWN to increase/decrease the setting (0-5 sec)

• Press LEFT or Press CENTER of D-Pad to save setting and

return to SYSTEM menu

PRES SIZE – There are two font size options for displaying the

Regulator Pressure – Large or Small.

• The screen displays whether the PRES SIZE setting is Large or

Small

• Press RIGHT or Press CENTER of D-Pad to change the Pres Size

setting (default is Small)

• Press UP or DOWN to switch the setting to either SMALL or LARGE

• Press LEFT or Press CENTER of D-Pad to save setting and return to SYSTEM

System (SYS) Sound - Turns the system sounds ON or OFF, including the

startup, shutdown, and enter/exit menu sounds.

• The screen displays the current setting of either ON or OFF

• Press RIGHT or Press CENTER of D-Pad to change the System Sound (default

is ON)

• Press UP or DOWN to cycle through ON or OFF

• Press LEFT or Press CENTER of D-Pad to save setting and return to SYSTEM

JSTK Sounds - Joystick Sounds: Enables a beep when the joystick is activated

when setting is ON.

• The screen displays the current setting of either ON or OFF

• Press RIGHT or Press CENTER of D-Pad to change the Joy

stick Sound setting (default is ON)

• Press UP or DOWN to cycle through ON or OFF

• Press LEFT or Press CENTER of D-Pad to save setting and return

to SYSTEM Menu

Lube Alert - This setting turns the Slick Assistant lube alerts ON or

OFF. The Slick Assistant lubrication monitoring system will alert

the user if it is time to re-lube the marker. This alert plays a sound

and shows a special alert message on screen when the marker is

turned on. It also plays a sound if the Slick Assistant Lube Gauge is

displayed during live mode.

• The screen displays the current setting of either ON or OFF

• Press RIGHT or Press CENTER of D-Pad to change the Lube Alert setting (default is ON)

• Press UP or DOWN to cycle through ON or OFF

• Press LEFT or Press CENTER of D-Pad to save setting and return to SYSTEM Menu

Reset Lube - This setting will reset the lube gauge. This should be reset each time the marker

is lubed. Two choices reset or cancel

Training - When training mode is ON, while in Live Mode, instead of

the marker cycling the solenoid, it will chirp quickly. The eyes are

bypassed. This is for users to practice trigger activation without the

need for an air source. Note – the marker will not ﬁre while training

mode is on.

• Press RIGHT or Press CENTER of D-Pad to see if Training Mode

setting is On or OFF

• Press UP or DOWN to cycle through ON or OFF (default is OFF)

• Press LEFT or Press CENTER of D-Pad to save setting and return

to SYSTEM Menu