Specifications

11
www.empirepaintball.com
THERE ARE 4 FIRING MODES:
- Semi-Auto/NPPL (1 Flash) – One shot per trigger pull. Max ROF capped at
20 BPS.
- Ramping/PSP (2 Flashes) – The MINI will operate in semi-auto mode for the
first 3 shots; then if player achieves the minimum trigger pull as defined by
the Ramping Point value in Function 5, which is defaulted to 4 trigger pulls
per second for this mode, the MINI will ramp to the Rate-of-Fire value in
Function 2, which is defaulted to 13 shots per second for this mode.
- Full-Auto/NXL (3 Flashes) – The MINI will operate in semi-auto mode for
the first 3 shots; then pull and hold trigger on the 4th shot, and the MINI will
fire full-auto at the Rate-of-Fire value in Function 2, which is defaulted to 13
shots per second for this mode.
- Ramping/Millen. (4 Flashes) – The MINI will operate in a semi-auto mode
until player achieves the minimum trigger pull as defined by the Ramping
Point value in Function 5, which is defaulted to 6 trigger pulls per second
for this mode. At that point, and as long as 6 trigger pulls per second are
maintained, the MINI will ramp to the Rate-of-Fire value in Function 2, which
is defaulted to 10 shots per second for this mode.
Note: After modes 2 through 4 are selected, it is possible to raise or lower both the Rate-of-Fire
and Ramping Point values in case the tournament rules change.
To cycle through the Firing Modes you use both the Power Button and
Function Key. Once you push the Function Key one time to get into the Firing
Modes the LED will flash Red. While the LED is lit Red, push the Function
Key to cycle up (from 1 for Semi to 4 for Full Auto) and to go the opposite
direction (from 4 at Full Auto through to 1 for Semi). Use the Power Button
to cycle down.
Example: If you are in the Default Semi-Auto mode and want to go to
Full-Auto/NXL, Push the Function Key twice while the LED is lit Red. Upon
release you should see the LED flash red 3 times. To move from Full-Auto/
NXL to Ramping/PSP, push the Function One time to get into firing modes,
then while LED is lit solid Red, push Power Button one time and release. The
LED should flash Red two times to indicate that you are now in Firing Mode
2-Ramping/PSP.
MAX RATE-OF-FIRE (ROF)
-WILL BE INDICATED BY SOLID GREEN LED
To get into the ROF Function, make sure Power is Off, then push Function
Key two times and LED will turn to a solid Green and then flash to indicate the
Rate-of-Fire (1-20) that you are currently using. Default is 20 Bps (balls-per-
second). To adjust ROF push the Function Key two times and while the LED
is lit a solid Green use either the Function Key (to toggle up or increase your
ROF) or the Power Button (to decrease the ROF).
DWELL SETTING
- WILL BE INDICATED BY SOLID ORANGE LED
To get into the Dwell Function, make sure the Power is Off, then push
the Function Key three times and the LED will turn to a solid Orange and
then flash to indicate the Dwell Setting that you are currently at. The MINI
Dwell Setting is defaulted at setting 28 (28 x .25 milliseconds = 7 ms).
Dwell is adjustable from 1 to 45. This Function is also controlled through
the same techniques used for Firing Modes and ROF Functions, while the
LED is lit a solid ORANGE, increase or decrease your Dwell by increments
of .25 milliseconds.