Owner`s manual
12426-15-0811Page 12
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING:
may result causing property damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted by
hand. When lighting the pilot, follow these instructions
exactly.
B. BEFORE LIGHTING smell all around the appliance area
WHAT TO DO IF YOU SMELL GAS
do not use any phone in your building.
phone. Follow the gas supplier's instructions.
-
ment.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
or explosion.
D. Do not use this appliance if any part has been under water.
the appliance and to replace any part of the control system
and any gas control which has been under water.
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to lowest setting.
2. Turn off all electric power (if applicable) to appliance if
service is to be performed.
3. Remove control access panel (control door).
4. Push in gas control knob slightly and turn clockwise
to "OFF." Do not force.
5. Replace control access panel (control door).
1. STOP! Read the safety information above.
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance (if applica-
ble).
4. Remove control access panel (control door).
5. Push in gas control knob slightly and turn clockwise
to "OFF."
NOTE:
unless knob is pushed in slightly. Do not force.
6. Wait ten (10) minutes to clear out any gas. Then smell
Follow "B" in the safety information above. If you don't
smell gas, go to the next step.
7. Find pilot - follow metal tube from gas control. The pilot
is mounted on front of main burner.
8. Turn gas control knob counterclockwise
to "PI-
LOT."
9. Push in control knob all the way and
hold in. Immediately light the pilot with
a match. Continue to hold the control
knob in for about one (1) minute after
the pilot is lit. Release knob and it will
pop back up. Pilot should remain lit. If
it goes out, repeat steps 5 through 9.
-
control knob to "OFF" and call your service technician
or gas supplier.
10. Turn gas control knob counterclockwise
to
"ON."
11. Replace control access panel (control door).
12. Turn on all electric power to the appliance (if applica-
ble).
13. Set thermostat to desired setting.
LIGHTING INSTRUCTIONS
GAS CONTROL KNOB SHOWN IN "OFF" POSITION
LIGHTING INSTRUCTIONS