User Manual

EMPIREBATTLETESTED.COM
6
Removing End Cap/Stock, Spring Guide,
Bumper and Spring
1. Remove the Rear Trigger Frame pin as described
previously in the Splitting the Body section
2. Split the upper shell from the lower, making sure the
barrel plug stays seated to not interfere with the upper
shell pivoting
3. Locate the pin that holds the End Plug in
place (Fig. 4.4)
4. Push the pin out of the lower Body, making sure
that you do not try to push the knurled end
5. Once the End Cap Pin is removed, the End Cap
can be taken o the Body, being careful not to lose
the Spring and Spring Guide (Fig. 4.5).
Removing Barrel Adapter, Front Bolt,
Rear Cocking Bolt and Linkage Arm
1. Split the Upper and Lower Receiver
ass described previously in this section
2. This now allows access to the Front
Bolt, Rear Cocking Bolt and Linkage
Arm (Fig. 4.6)
3. Remove the Linkage arm
4. Remove the Barrel Adapter from the
Lower Receiver/Body
5. Slide the Front bolt forward along the
power tube until free and remove
6. Slide the Rear bolt rearward and
remove (Fig. 4.7)
Removing Ball Detent
1. Remove the Front Bolt and Barrel Adapter
as described previously
2. Locate the Detent Shell (Fig. 4.8)
3. Remove the Detent Shell and Detent from
the Lower Receiver
4. Once free of the Receiver, the Detent can
be removed from the Detent Shell (Fig. 4.9)
Reassembly
To reassemble the marker, reverse the Disassembly
instructions star ting with the barrel adapter, ball detent
and front bolt removal. While reassembling the marker,
you should oil all O-rings and sliding par ts. All parts and
o-rings returned to the marker should be free of debris
and visual nicks and scratches which can alter the performance of the marker. All
screws returned to the marker must be tightened so there is no chance of them
vibrating loose.
Fig. 4.4
Fig. 4.5
Fig. 4.6
Fig. 4.7
Fig. 4.8
Fig. 4.9