User Manual

EMPIREBATTLETESTED.COM
5
Disassembly/Reassembly (continued)
Disassembly Tips
• Make sure you have a clean area to work on your marker.
• When separating the Shell for the first time, do so carefully, so you do not lose any parts.
• Visit PaintballSolutions.com for additional information.
Barrel Removal
Turn the bar rel counter clockwise to remove it from the
marker. Keep your barrel clean for best results.
Slide-Away™ Elbow Removal
1. Press and hold the retention button located on the
name plate side of the Slide-Away™ Elbow (Fig. 3.7).
2. Slide the Elbow toward the front narrow gap of the marker and remove.
3. Reverse process to replace Slide-Away™ Elbow.
Front Foregrip Removal
1. Locate the bolt that secures the foregrip to the
body (Fig. 3.8).
2. Unscrew the bolt using a 5/32” Allen wrench
and remove it completely from the foregrip.
3. Once the bolt is free, the foregrip can be slid o
the Picatinny rail.
4. Reverse the process to install the foregrip.
Splitting the Body
1. Locate the Rear Trigger Frame Pin (Fig. 3.9)
2. Push the pin through the body and remove
completely from the marker shell
3. Pull the upper and lower shells apart, making
sure the barrel plug does not impede the split
4. Once the shells are apart, you can now access
the internals for maintenance and repair (Fig. 4.0).
Note: It may not be necessary to loosen the 3 screws on the Delta rear sight;
see if it slides o rst.
Trigger Frame Removal
1. Remove the Rear Trigger Frame Pin as
described in the Splitting the Body section
2. Locate the second Spring Pin on the
Trigger Frame (Fig. 4.1).
3. Push the pin through the marker body
and then pull it free of the Trigger Frame
4. Lower the Trigger Frame from
the Receiver
Note: The frame will still attached to the receiver by the steel braided hose. It is
recommended that you do not remove the hose from the valve or the tank adapter.
Receiver (Body) Separation
Make sure the marker is in the un-cocked (forward position) before
taking body apart.
1. Remove the Rear Trigger Frame pin as described
previously in the Splitting the Body section
2. Remove the Front Trigger Frame pin as described
previously in the Trigger Frame
Removal section
3. Locate the Front Body Pin (Fig. 4.2)
4. Push the pin through the marker and then pull it
free of the Body
5. Lift the upper half of the Body free from the
lower half
6. All components are now accessible for
maintenance or repair (Fig. 4.3)
Note: The end cap/stock will be under some spring tension and may spring out
when the top name plate receiver is lifted o.
Note: The retention screw located below the bolt handle slot is longer than
the rest.
Fig. 4.0
Fig. 4.1
Fig. 4.2
Fig. 4.3
Fig. 3.7
Fig. 3.8
Fig. 3.9