Manual

12
Markerdoesnotre/cycle Markermaynotbeturnedon Check screen on rear of foregrip. OLED screen should be on when
marker is turned on.
Paintballsmaynotbefedintobreech Theanti-chopeyesystempreventsthemarkerfromringunlessa
ballispresent.Whentheeyesdetectaballtheeyesymbolonthe
screenwillhavealledcircleinthemiddle.Neverputanything
other than a paintball down the feedneck of the Mini GS. Check that
theboltisfullyreturningandifnotserviceyoumayneedtochange
bolt tip, small bolt guide o-rings and/or the bolt o-rings. Check that
there is a proper connection between the sensor board and main
board. Check for damage to the main board pins near the tip of the
foregrip.
Triggermayneedtobeadjusted. The trigger indication aarow takes place of the tournament lock
symboltwhenthetriggerisactivated.Ifthetriggerisbeingpressed
the aarow will point down, and point up if the trigger is released. If
itisnotthatway,thenthetriggermayneedtobeadjusted.Seethe
“TriggerAdjustments”sectionearlierinthemanual.Checkthatthere
is a proper connection between the sensor board and main board.
Check for damage to the main board pins near the tip of the foregrip.
Solenoidmaynotbeconnected Remove air source and paintball before disassembling the marker. If
yourremovethegripframeyoushouldbeabletoverifythesolenoid
is plugged into the Mini GS sensor board.
Multiplepaintballsredfromonlyoneshot Balldetentsmaybetornormissing Removetheeyecovertochecktheconditionoftheballdetents.If
damagedorbentpermenantlyreplaceoneorbothofthem.
Marker is Breaking paintballs in the breech Balldetentsmaybetornormissing Removetheeyecovertochecktheconditionoftheballdetents.If
damagedorbentpermenantlyreplaceoneorbothofthem.
Eyesmaybedirty Cleantheeyesasdescribedearlierinthemanual.Iftheeyesare
dirtytheeyesymbolonthescreenwithhaveabigXinthemiddle
afterthemarkerisred.
Bolttipmaybebad Abadbolttipmayallowairtoesacpeupthefeedneckcausing
breakage.Thissymptomiscommonlyknownas“Blowback”
BoltguideorBolto-ringsmaybebad Badboltorsmallboltguideo-ringsmayallowairtoesacpeupthe
feedneckcausingbreakage.Thissymptomiscommonlyknown
as“Blowback”.Makesuretheseo-ringareingoodconditionand
properlylubricated.Replaceifnecessary.
Marker is shooting slower than set ROF Eyesmaybedirty WhentheeyesaredirtytheROFislimitedto8bpstoprevent
excessiveballbreakage.Cleantheeyesasdescribedearlierinthe
manual.Iftheeyesaredirtytheeyesymbolonthescreenwithhave
abigXinthemiddleafterthemarkerisred.
VelocityisLow/Inconsistentorvelocitydropsduringrapidre Poppeto-ringmaybedamagedornotproperlylubricated See general maintenance section earlier in the manual to see how to
properlycheckandlubricatepoppeto-ring.
BoltguideorBolto-ringsmaybebad/maynotbelubricated Boltshouldstayonboltguidewhenturnedboltsidedownandshak-
en. If bolt falls off replace 3 small bolt guide o-rings. Check bolt and
boltguideo-ringsfordamage.Assuretheseo-ringsareproperly
lubricated according to general maintenace section of this manual.
7. Troubleshooting