Owner`s manual
32084-6-0214 Page 15
Important
All correspondence regarding repair and service should
refer to complete Model Number, Serial Number and type
of gas.
ACCESSORIES
VENTING
Part Number Description Typical Uses
PVSA1 Air Pipe Kit Converts wall furnace from single ue to direct-vent
PVSDV35A DV35 Vent Transition Cap Replaces DV35 Vent cap with a transition to PVC pipe for a 2” single ue.
SHROUDS
Part Number Description Typical Uses
PVSDS1 Deep Rear Shroud Allows venting to be run in front of the wall in on the oor installations
PVSWS1 Wall Mount Shroud Allows installation of wall furnace off of the oor
CONDENSATE KITS
Part Number Description Typical Uses
PVSHT1 Heated Humidication Tray Evaporates condensate as humidity back into the room
PVSEP1 External Condensate Pump Pumps condensate away from wall furnace instead of gravity drain
PVSCT10 Condensate Hose Extension 10 ft condensate drain extension
CONTROLS
Part Number Description Features
PVSRT1 Temperature Sensor Relocation Kit Room Temperature Sensor Extension
FRBTPL Battery Remote Control,
Programmable Thermostat, Backlit
Manual or Thermostatic Operation, Modulating, 10 Preset Weekly Programs
Notice: Following a power outage, this wall furnace will not automatically resume operation when operated manually or
with the internal thermostat. Once power is restored, the wall furnace will automatically power on in “Remote Mode” (--),
and the original operation settings will need to be re-entered. Installing an optional Millivolt thermostat control allows the
wall furnace to automatically resume operation under that thermostat’s control once power is restored. Ask your dealer for
details.
INTRODUCTION
ACCESSORIES
Removing the Front Panel
It may become necessary to remove the front panel of the
appliance to remove dropped or fallen objects.
Remove the front panel by lifting up then pulling out. Re-
place the panel by reversing this step.
WARNING
FOR YOUR SAFETY, TURN OFF POWER TO APPLIANCE.
WARNING
Do not operate this appliance without the front panel.