Owner`s manual

28188-1-0711 Page 7

Placereboxinframingopening.Usethefour(4)framingbrackets
providedonthereboxtoattachreboxtoframing.Differenthole
locationscanbe used fornishingmaterialswiththicknesses of
3/8",1/2"and3/4".Attachthesematerialswithscrewsprovided,
two (2) per framing bracket. 
Framingbracketsshouldtdirectlyagainstframingmaterial.Use
at least one (1) nail per bracket to secure in place.
Checksquarenessofthereboxpriortosecuringtoframedopening.
See Figure 8.

Ablackhoodthatisfurnishedwitheachrebox(oroptionalhood)
MUSTbeinstalledbeforethereboxisused.Failuretodosomay
createapossiblerehazard.Thehoodislocatedinsidetherebox
onushfaceunits.Ifbrass,stainlesssteel,orhammeredpewter
hoods are desired, they can be purchased as an option. Attachment
is the same as the standard black hood.
Flush Face Models
1. Onushfacemodels,loosenthetwoscrews(A)holdingrebox
toptofacepanel,thenslidethehoodangebetweentherebox
top and face panel and re-tighten the screws.
2. Install one (1) screw at each end of the hood as shown (C).
A
C
A
C
Flush Face Models
Figure 9
FIREBOX OPENING
CHECK TO SEE
THAT BOX IS SQUARE
PRIOR TO ATTACHING TO
FRAMING
Figure 8

INSTALLING HOOD