Owner`s manual
32273-4-1214 Page 11
7. Secure the non-combustible board to the middle bracket
Figure 11
the 1/2 inch non-combustible board provided with the unit.
2. Connect the side framing studs to the top stud as shown in
Figure 12. The channel of the studs should face inward.
Figure 12
head screws.
Note: If using a drain tray, the bottom of the side framing studs
4. Locate the middle bracket. Loosen the screw in the middle
shown in Figure 10. Tighten the hex-head screws on the
and into the top stud.
5. Locate the two non-combustible boards and place them
screws.
6. Secure the non-combustible board to the middle bracket
unit and check for leaks with a soapy water solution.
Note: Ensure that the gas shut-off valve is accessible.
as shown in Figure 9.
5. Connect the gas line to the unit and check for leaks with a
soapy water solution.
Note: Ensure that the gas shut-off valve is accessible.
6. Locate the two non-combustible boards and place them
screws.
Figure 10
FIREBOX FRAMING AND INSTALLATION










