Owner`s manual

16940-3-1107 Page 17
. ...
.
Wiring
The appliance, when installed, must be electrically grounded in
accordance with local codes or, in the absence of local codes, with
the National Electrical Code ANSI/NFPA No. 70, if an external
electrical source is utilized. This appliance is equipped with a
three-prong [grounding] plug for your protection against shock
hazard and should be plugged directly into a properly grounded
three-prong receptacle. Do not cut or remove the grounding prong
from this plug. For an ungrounded receptacle, an adapter, which
has two prongs and a wire for grounding, can be purchased,
plugged into the ungrounded receptacle and its wire connected
to the receptacle mounting screw. With this wire completing the
ground, the appliance cord plug can be plugged into the adapter
and be electrically grounded.
CAUTION: Label all wires prior to disconnection when
servicing controls. Wiring errors can cause improper
and dangerous operation. Verify proper operation after
servicing.
Oiling Blower Motor
The blower motor does not have oiling holes. Do not attempt to
oil the blower motor.
WARNING:
Unplugging of blower accessory will not stop the heater
from cycling. To turn off gas to the unvented heater: Push in
gas control knob slightly and turn clockwise to "OFF." Do
not force.
Index Part
No. Number Description
1 R-1468 Bushing
2 VF-153 Mounti
ng Bracket
3 R-2695 Motor
4 R-2696 Fan Blade
5 R-2503 Fan Control
6 R-2395 Wire Assembly
7 VF-068 Cord Set
PARTS LIST
If any of the original wire as supplied with the appliance must be replaced,
it must be replaced with type 125°C wire or its equivalent.
OPTIONAL BLOWER INSTALLATION INSTRUCTIONS (continued)