Owner`s manual

28096-18-0115Page 14
Pilot Flame Pattern (Figure 4)
Figure 4 shows a correct pilot ame pattern. The correct ame will
be blue and will extend beyond the thermopile. The ame will sur-
round the thermopile just below the tip. A slight yellow ame may
occur where the pilot ame and main burner ame meet.
After use, cleaning of the pilot burner may be required for the proper
ame. The pilot orice can be cleaned with high pressure air or
by placing under running water. Pilot orice must be dry before
replacement. Use a pipe cleaner to clean inside the pilot after the
pilot orice has been removed.

1. Disconnect the pilot supply line at the pilot burner.
2. Remove pilot orice from pilot burner. It may be necessary to
tap on pilot burner in order to remove the pilot orice.
Pilot Flame Pattern
Figure 4
If pilot ame pattern is incorrect
• See Troubleshooting, page 17.
Main Burner Flame Pattern
The main burner ame will be completely yellow.
Main Burner Flame Ignition and Extinction
When the main burner is ignited it will take a few seconds for the
full ame pattern to develop.
When the main burner is extinguished it will take a few seconds for
the ames to disappear.
PILOT AND MAIN BURNER FLAME CHARACTERISTICS
Keep the control compartment, logs and burner area surrounding
the logs clean.
        
COOL.
Always keep the appliance area clear and free from combustible
materials, gasoline, and other ammable vapors and liquids.
Never obstruct the ow of combustion and ventilation air. Keep the
front of the appliance clear of all obstacles and materials.
Cleaning Instructions
This appliance is built using mostly high-grade stainless steel to
resist rust-through. In outdoor applications, all stainless steel will
develop a dull patina and, depending on the local environment
CLEANING AND SERVICING
and on the materials used in the installation, may develop some
surface oxidation (rust). This does not affect the performance of
the replace, and does not require any action to correct. If you
prefer keeping your replace front looking factory-fresh, clean it as
required with stainless steel cleaner.
When installation application includes highly acidic applications
such as mortar or stone etching, do not remove the protective
PVC lm from the stainless steel until after this application is com-
plete. Once the lm has been removed we recommend that the
appliance be cleaned with a stainless steel cleaner immediately.
Please note that areas where the lm has been formed (corners,
hems, etc.) may require extra cleaning due to the properties of
the lm. Ensure that all protective lm has been removed from the
replace prior to burning the appliance.