Owner`s manual
29898-8-1114Page 32
CAUTION: ALL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRICIAN AND SHALL BE IN COMPLIANCE WITH ALL LOCAL,
CITYANDSTATEBUILDINGCODES.BEFOREMAKINGTHEELECTRICALCONNECTION,MAKESURETHATMAINPOWERSUPPLY
ISDISCONNECTED.THEAPPLIANCE,WHENINSTALLED,MUSTBEELECTRICALLYGROUNDEDINACCORDANCEWITHLOCAL
CODESOR,INTHEABSENCEOFLOCALCODES,WITHTHENATIONALELECTRICALCODEANSI/NFPA70(LATESTEDITION).
A factory installed junction box is located on the lower right hand
side of the replace. Wiring must be fed to the junction box and
attached to the receptacle that is provided. Remove the knockout
in the installed junction box to accept wiring into the junction box.
Install a UL listed cable clamp (not supplied) in the knockout hole.
Leave approximately 6" of wire in the junction box for connection.
Attach black wire to one side of the receptacle and white wire to
opposite side of receptacle. The ground wire should be attached
to the green (neutral) screw.
Install the receptacle into the junction box. Attach cover plate.
BrickLinerVPP32AandVPP36A
1. Remove screen from replace.
2. Remove branch log and rear log from burner assembly.
3. Insert back panel into rebox.
4. Insert one (1) side panel into rebox.
5. Use two (2) brick panel brackets to secure side panel. Align
clearance hole on brick panel bracket with screw hole in the
left or right interior, top and bottom of rebox. Use two (2)
10 x 1/2" screws to attach brick panel bracket to interior top
and bottom of rebox.
6. Repeat steps 4 and 5 to install second side panel.
7. Replace rear log and branch log onto burner assembly.
8. Replace screen onto replace.
9. Installation of optional brick liner is completed.
Figure28
Figure 29
PART NAME VPP32A
PART
NO.
VPP36A
PART NO.
BRICK PANEL SIDE - LEFT R8692 R8695
BRICK PANEL SIDE - RIGHT R8693 R8696
BRICK PANEL BACK R8694 R8697
BRICK PANEL BRACKET (4 REQ’D) 19401 19401
JUNCTION BOX WIRING INSTALLATION INSTRUCTIONS
OPTIONAL BRICK LINER INSTALLATION INSTRUCTIONS










