Owner`s manual

29898-8-1114 Page 15
1. Place replace in framing opening.
2. Using the four (4) nailing anges provided with the replace,
attach two (2) anges on each side. Attach anges through
prepunched holes. Additional hole locations will be used for
different nishing material with thicknesses of 1/2”, 5/8” and
3/4”. Attach these anges with screws provided, two (2) per
nailing ange.
3. Nailing anges should t directly against framing material. Use
at least one (1) nail per tab to secure in place.
VFP32BP VFP36BP
"A" 36 1/4" 38 1/4"
"B" 34 1/2" 39 1/2"
"C" 17 7/8" 17 7/8"
Attention: Add 3 3/4" to "A" Dimensions when using ush mantel
base.
Figure 12
Fireplace framing can be built before or after the replace is set in
place. Framing should be positioned to accommodate wall covering
and replace facing material. The replace framing should be
constructed of 2 x 4 lumber or heavier.
NAILOR OTHER SUITABLE FASTENER
Figure 10
Figure 11
FIREPLACE FRAMING AND INSTALLATION