Use and Care Manual

II. Description on Using Parts
1. Heater/Thermostat
1) Normal starting up time is 4-8 hours
2) SPA Thermostat cannot be heated by man in the air, or there will be danger. If there is something wrong
in operation, professional servant is a must to prevent the risk of electricity leakage.
2. Air pump
Normal working time is 15-30 minutes (air pump shall not be working continuously over 120min., because
it may overheated the whole part or shorten service life ).
Please notice that water level should not be 7cm over the tub water level to prevent air pump being burnout
by water leakage.
3. Paper element filters daily maintenance
Type one
14
:
1) Remove the outer cover of the skimmer2) Pull out the skimmer screw;3) Take out the paper core;
4) Wash the paper core with water, reset it after cleaning and dry out;
Type two:
1) Pull apart the crystal package of the paper core; 2) Pull out the cover of filtration bucket;
3) Match the paper core inside and screw it tight, then put the cover of filtration bucket back.
Type three:
Filter
Remove
filter cover
Paper
cores
Unscrew the paper
core
counterclockwise
Put the
cover back
Type four:
1) Remove the cover on the filter, and screw the core paper filter out.
2) Repeatedly Clean the core paper filter with water.
3) Put the core paper filter back to use after dry out.