Use and Care Manual

49
Exhibit A
Correct Position for Dual Burner
Here’s the procedure to check the condition for our current burner design. The procedure helps the
electrode to sense the flame correctly
1. Make sure the Burner Design is correct. Our current design for the burner is having the electrode
on the left side (10 o’clock) and cross-over on the right side (2 o’clock). There are four parts for the
dual burners. They are burner cap, flame ring base, flame ring and burner base.
2. Make sure the electrode is going through the hole on the flame ring and it is vertical to the
surface of flame ring base.
3. For the flame ring base part. make sure that the electrode will go through the hole on the 10
o’clock position. Make sure the electrode is not going through the hole next to the cross-over.