Use and Care Manual
Table Of Contents
- Warnings
- Welcome
- Before you start
- Safety and Warnings
- Safety Symbols
- Electrical Shock Hazard
- Tipping Hazard
- Explosion Hazard
- Fire Hazard
- Poisoning Hazard
- Hot Surface Hazard
- Other Safety Tips
- Stove Models
- HRG 36” Freestanding gas range
- HRG 30” Freestanding gas range
- Gas Supply Requirements
- Safety Tips for Gas Operation
- Dimensions and Clearances
- Electric Power Supply Requirements
- Electrical Grounding Instructions
- 10. First Use
- Conditioning the oven
- Positioning the shelves
- Surface Burner Ignition
- Simmer and Boil
- Flame Size
- Power Failure
- Cooktop
- Burner Grates
- Oven burner use
- Broil burner use
- Oven cooking guidelines
- 12. Oven Function
- Natural Airflow Bake
- Infrared Broil
- Convection Bake
- Convection Roast
- Convection Defrost
- Defrosting
- Convection Dehydration
- 13. Broiler Operation
- Preheating
- To Broil
- Setting Broil
- Broiling guidelines
- 14. Cleaning Instructions
- Do’s
- Don’ts
- Cleaning Burner caps and brass flame spreaders
- Cleaning side racks
- Cleaning oven shelves
- Cleaning broil/roast pan and slotted grid
- Cleaning bake and broil burners
- Cleaning porcelain surfaces
- Cleaning the oven glass window
- Cleaning the oven door gasket
- Cleaning stainless steel surfaces
- 15. Replacing the burner parts
- Removing and replacing the oven door
- Removing the oven door
- Replacing the oven door
- Replacing the oven light bulb
- 16. Troubleshooting Guide
- Cooktop
- Oven
- 17. Warranty & Service
- Warranties and Duration
- Thor Group will pay for:
- Thor Group will not pay for:
- 18. Warranty and Product Registration
- Exhibit A
- Correct Position for Dual Burner
Dimension and Clearance
20
Electric Power Supply Requirements
Your range must be electrically grounded in accordance with local codes or, in the absence of local
codes, in accordance with the National Electrical Code (ANSI/NFPA 70, latest edition).
In Canada, electrical grounding must be in accordance with the current CSA C22.1 Canadian
Electrical Code Part 1 and/or local codes. A copy of this standard may be obtained from: National
Fire Protection Association, 1 Battery march Park, Quincy, Massachusetts 02269-9101.
The power supply must be the correct polarity. Reverse polarity will result in continuous sparking of
the electrodes, even after flame ignition. If there is any doubt as to whether the power supply has
the correct polarity or grounded, have it checked by a qualified electrician.
Use 120V, 60Hz, and properly grounded branch circuit protected by a 15-amp or 20-amp circuit
breaker or time delay fuse.