User manual

exceeds the specifications, see section 2 Product Specifications. The next cause can be
the overheating of product in consequence of wrong installation, see section 4 Product
Storing and Installation. Disconnect the product from the power grid, remove the cause,
and re-plug the product into the power grid after a few minutes again.
If the failure cannot be removed, please contact your distributor.
10 S ymbols Explanation
certificate of conformity
for indoor use only
DC power supply
grounding
class II device
fuse protected
safety transformer
According to EU directive, electric and electronic devices which are identified by
one of the following symbols must not be disposed of together with municipal
waste. When disposing of the old device, use local waste collection and separation
systems.
11 Wiring Diagrams
Power Supply Specifications P1U15
Input Voltage 90-265 V AC, 50/60 Hz
Output Voltage 18 V DC
Maximum Output Current 0.8 A (18 V DC)
Maximum Output Power 15 W
Efficiency 75% min
Dimensions (w,d, h) 12.6 x 15.2 x 8.7 cm (power cord length 130 cm)
Temperature Range -30 - +70 °C
3 Product Takeover
Make sure that the product is not damaged and following accessories are enclosed:
• 75 Ω loads for the impedance matching of unused outputs (2 pcs, others can be ordered
from EMP-Centauri, code 1000066).
In the case of damage or missing accessories please contact your dealer.
4 Product Storing and Installation
The product must not be stored and installed
• in the place with excessive humidity,
• in the place with dropping or running water,
• in the place with high dust pollution, mechanical vibrations or impacts,
• in the place out of temperature limits specified in the section 2 Technical Specifications,
• close to heat sources (radiators or air ventilators, direct sunshine etc.),
• in the reach of children.
Fix the product firmly on a wall or another hard and inflammable surface with screws and
dowels. The mains socket must be placed near the product. The mains socket and plug must
be easily available.
• The product shall be in no case held only by the connected cables.
• Ensure the free space for the air circulation (space on sides and bellow the product
should be at least 20 cm and the space over its top at least 50 cm).
• Do not cover the product (with curtains etc.).
• Do not place any containers with liquids (vases, glasses etc.) or naked flame sources
(lighted candle etc.) on the product or near the product.
5 Product Connection
Connect the product in accordance with this manual and valid regulation. Use high-quality 75 Ω
coaxial cable designed for satellite reception. Mount the F connectors (screw, crimp or compress
type) on the ends of coaxial cables, in the case of using the screw F connectors proceed according
to the following picture and instructions:
1. Remove the outer coaxial cable coating in the length of approx. 15 mm.
2. Roll up the metal shielding braid and the shielding foil underneath and cut the shielding
with scissors to approx. 5 mm.
3. Remove approx. 10 mm of the inner plastic insulation (approx. 5 mm of the insulation
remains in a place).
6 z 8
3 z 8