User's Manual

36 eMotimo spectrum Instructions R007
Telemetry Menu
This screen displays live feedback from the PS4 and the NavStick can be read for diagnostic
purposes. Nothing can be changed on this screen.
Remote Pairing – For new remotes only
When not to do it – Your remote comes pre-paired from the factory. If the remote has been
connected previously, please just use the quick reconnection by powering on your spectrum
and pressing and releasing the remotes PS button. The remote will slow blink and turn blue,
indicating a connection has been made.
If you replace the remote, with a new one or one that didn’t ship with the spectrum, you will
have to pair it once. To do that follow these steps:
a. Power the spectrum. Using the NavStick, select the settings menu and move
the pointer to Pair New Remote, but do not select it. The text will remain non-
highlighted.
b. On the PS4 remote, Press and hold the Share button. While still holding the share,
press and hold the PS button.
c. Watch the remote LED and once it starts a fast, short blink, release both buttons.
d. On the spectrum, now select the Pair New Remote by hitting the NavStick center
button. The selection will highlight for a moment.
e. The remote is now pairing. When complete the LED will light blue on the remote,
and the screen with “unhighlight” the text.
f. The remote is now active. Note this procedure should not have to be run again
unless the remote is paired to another system, or the remote is new, or the dongle
was replaced.
Version
This ST4 rmware version currently running is listed out here.
Settings Page 4/4