User's Manual

Settings: Settings and motor preset selection will retain after a

power down.

Brightness:

Adjust your display brightness here by pressing X button on PS4 controller or center button

on NavStick to select. This is the brightness of your display for normal operations (navigating

menus, programming a move, etc.).

Brightness Run:

Adjust the brightness of your display for the duration of a programmed move. This brightness

setting only comes into play once you start your programmed move. Press X button on PS4

controller or center button on NavStick to select. Once selected move up and down to adjust.

You can set this brightness to 0 and have your display turn o󰀨 completely during a move to

avoid any unwanted light.

Screen Flip:

Are you under-slinging spectrum? Need to invert the screen to read it? Press X button on PS4

controller or center button on NavStick to select. Once selected move up and down to adjust.

Press X to select.

Slider:

What slider are you using? Select it here. This setting will change what motor proles you can

select under the Live Motion menu. If you are using a slider that is not listed out here, such

as Dynamic Perception, Rhino, or Kessler, please select the iFootage slider. Please note,

iFootage turbo mode will only work on Direct Drive motors on the iFootage slider. Press X

button on PS4 controller or center button on NavStick to select. Once selected move up and

down to adjust. Press X to select.

Settings Page 1/4