User's Manual
13Copyright © 2018 eMotimo INC
Quick Reconnection
Remote Charging
Disconnecting
the remote while the rig is
running
Resetting a remote
Reconnecting
the remote while the rig is
running (in progress)
1.
1.
2.
2.
3.
4.
Remote Information
Quick connection should be used unless your remote is new.
Power on the spectrum, wait until main menu shows on the
screen.
Immediately Press and release the PS button (middle) of remote.
The PS4 remote’s LED will ash white in a slow even blinks while
it is trying to connect. When the remote connects, the LED will
show solid blue and is ready for use.
If the remote does not connect and stops ashing, press the PS
button to retry the connection.
If the remote doesn’t connect by indicating a solid BLUE on the
second try, unplug the spectrum st4 from power, wait for the
remote’s LED to turn o and start the remote pairing procedure
outlined above.
Make sure your remote is fully charged before you head out
into the eld.
Plug in a micro USB cable (not included, but typical of many
phones / cameras) to the PS4 and then USB end to a computer.
Look for an orange glow on the back of the PS4 while it is
charging. Once this turns o it is fully charged.
Watch out! Many eld packs with USB ports will not charge the
PS4. Use the orange glow as an indicator that the charging
process is working.
To save the remote’s batteries once a program is running, you
may disconnect the remote by pressing and holding the PS button
for 1 second. or simply walk out of range and it will disconnect.
On rare occasions, a remote’s battery gets really low or sits for a
long period of time, it might not charge (indicated by orange glow).
If it isn’t charging or connecting, reset it. You can do this by using
a thin tool to press the reset button on the bottom of the remote.
To reconnect, hit the PS button one and release. The remote
will ash white slowly while trying to reconnect. If this process
doesn’t reconnect a power cycle of the unit may be required.
Hint - NavStick– even if reconnection is having troubles or your
remote is out of batteries, you can still use the NavStick on the
side of the spectrum to start or reverse a programed move after a
shot is complete.