Datasheet

Data Sheet
Version: A-0
Page: 7/7
Notes:
1. Do not dispose of cell into fire or be dismantled under any condition.
2. Do not mix different cell types and capacities in the same battery assembly.
3. Charge and discharge under specified ambient temperature recommended to YUTONG specification.
4. Short circuit leading to cell venting must be avoided.
5. Never solder onto cell directly.
6. Cell reversal should be avoided.
7. Use batteries in extreme condition may affect the service life,such as˖extreme temperature,deep cycle,
extreme overcharge and over discharge.
8. Batteries should be stored in a cool dry place.
9. Once problems be found, stop using, send batteries to local dealer.
10.
Storage
(1) It is strongly recommended to store Ni-MH batteries and cells in the temperature range from -20 to
25ć ,and in low humidity and no corrosive gas environment, to maintain a reasonably high capacity
recovery level.
(2) Avoid storage higher (e.g.35ć), lower temperature than –20ć, or higher humidity which would
result in deterioration or damage to the cells and batteries such as follows:
(3) Up to three full cycles of charge /discharge after long-termed storage may need to obtain
highest capacity.