Technical data

Page 14
2. CERTIFICATIONS
The induction generators must be considered “components” and not “finished products” and so they are submittted to
the controls of the IMQ, “Istituto del Marchio di Qualità”(Quality Brand Institution), in order to obtain the SCV-IMQ, the
“certificato di sorveglianza” ( “the supervision certificate” ) according to the following regulations:
STANDARD ON ELECTROMAGNETIC COMPATIBILITY
EN 61000 3-2::1995+A1; 1998+A2: 1998+A14: 2000
EN 61000 –3-3 1995
EN 55011: 1998
EN 55014: 1997
STANDARD ON ELECTRIC APPLIANCE FOR COLLECTIVE UTILISATION AND SIMILAR
En 60335-2-36: 2000 (PAR 10,17, 19.11, 24,25,26)
- mark CSV-IMQ
3. TRANSPORT
-The induction generators are carefully packed.Handle with care, and check the conditions of the packaging as soon as
you receive the goods. In case of damage, please contest the forewarder at the soonest.
-Storage: if the induction generator is not installed immediately, please store it without removing the packaging, at a
temperature range between 20° and 50° and dampness from 10% to 90%.
-Remove the packaging only in case of immediate installation.
-Keep the packagings materials in case of return of the goods to the supplier.
4. INSTALLATION
The induction generators must be considered “components” and not “finished products” so you must respect the laws,
the regulations and the standards in force in the different countries as far as low and medium voltage are concerned.
You also must respect the regulations on security of electric appliances for collective utilisation and the regulations on
electromagnetic compatibility.
To find copy of these regulations please contact the authorized institutions in the different countries where the installations
will be done.
Each generator is equipped with its electric layout showing the harness and its relatives connections.
On the layouts there are all the indications and all the references you can find also in the electrical and electronic
parts, in order to avoid any mistake in connecting the parts.
The layouts are attached to this manual”
5. POTS AND PANS
Induction generators only work properly with saucepans with an iron, cast iron or chrome-plated iron base.
These pans may also be enamelled.
The generators accept all the above type of saucepans and adapt in real time to supply the same power.
The pans must have a diameter of between 160 mm and 260 mm.
It is best for the bans to have a flat base.
The generator does not accept unsuitable pans.
Any other product no mentioned in this paragraph should be considered automatically excluded and unsuitable for use
with induction generators.