Technical data

Page 12
1.7 SAFETY OF THE PERSONNEL RESPONSIBLE FOR USE
The pyroceram area is heated by the heat of the saucepan.
To avoid burns, do not touch the heating zone.
To avoid excessive overheating, do not leave the empty saucepan on the heat or heat it for no reason.
When cooking with several saucepans at the same time, make sure that the handles do not cross each other and that
they are outside the field of induction.
The handles may become very hot depending on the type of material of which they are made.
Risk of burns! We recommend using oven gloves.
Saucepans must always be kept a small distance apart.
They should not touch each other.
When you remove the saucepan, it is advisable to switch off the cooking zone to prevent the heating system from
switching back on automatically should you happen to replace the saucepan.
Do not place other material (paper, card, fabric, etc.) between the saucepan and the cooking zone as it could catch fire.
Metal objects heat up very quickly if placed in the heating zone when it is in operation.
It is therefore advisable not to place objects other than saucepans on the induction hob (cans, closed tins, aluminium
trays, cutlery, rings, keys, watches, etc.)
People with pace makers should consult their doctor to find out whether they can work in the vicinity of a hob with
induction generator.
Do not place credit cards, phone cards, tapes or other magnetic objects on the pyroceram plate with induction system.
The induction generator has an internal cooling system.
Make sure that the air inlet and outlet holes are not blocked by objects (paper, rags or other).
This could cause overheating and lead the induction generator to switch itself off.
Do not allow liquids (water, oil or other) to enter the induction generator.
Do not clean the generator with a jet of water.
If the pyroceram top is cracked or broken, switch off the generator and disconnect the electricity supply.
Do not touch any of the internal parts of the induction generator.
1.8 SAFETY DURING INSTALLATION, MAINTENANCE AND CONTROLS
The personnel responsible for use must be qualified.
All installation, maintenance and control operations must be performed by personnel qualified to issue the relative
certificates requested by the relative authorities as regards safety
in the workplace.
Said personnel must study this manual in depth.
Only highly qualified personnel may install, maintain, service, repair and collect the induction generator component.
Said personnel must be trained by means of a specific training course authorised by the manufacturer as regards the
induction generator.
Moreover, they must meet the requirements set by the relative authorities as regards the electrical and electronic safety
of installations.
Generally speaking, work should only be carried out on the induction generator component after it has been disconnected
from the electricity supply.
The induction generator must be switched off and disconnected from the power supply and electricity network.
The safety and protection installations must be replaced and reinstalled at the end of the above operations, according
with the international, national and regional regulations and laws on safety, thus ensuring correct and safe usage of the
component.
1.9 REPRODUCTION OR USE OF UNAUTHORISED SPARE PARTS
Reproductions or changes to the induction generator component are not permitted.
Contact the manufacturer if you observe any changes to the induction generator.
To ensure safety, always use original spare parts, authorised by the manufacturer.
The manufacturer declines responsibility in the event in which non-original spare parts have been used.
1.10 IMPROPER USAGE
The proper working order of the induction generator components is only guaranteed in the event of correct usage as
described in this manual and as regulated by the international, national and regional laws and regulations on safety and
electromagnetic compatibility, which regulate components such as the induction generator.