User Manual

Installation
Before beginning installation of this product, please read the instruction manual and
warnings below carefully.
A visual inspection of this product for possible damage occured during shipment is recommended before
installation. It is your responsibility to ensure that qualified mechanical and electrical technicians install this
product.
Do not use the unit in combustible or explosive gaseous atmospheres.
Do not expose the unit to direct sun rays or any other heat source.
Do not place the unit in the neighbourhood of magnetic equipment such as transformers, motors or
devices which generate interference (welding machines, etc.)
To reduce the effect of electrical noise on device, Low voltage line (especially sensor input cable) wiring
must be separated from high current and voltage line.
During installation of the equipment in the panel, sharp edges on metal parts can cause cuts on the hands,
please use caution.
Mounting of the product must be done with its own mounting clamps.
Do not mount the device with inappropriate clamps. Do not drop the device during installation.
If possible, use shielded cable. To prevent ground loops the shield should be grounded on one end only.
To prevent electric shock or damage to the device, do not apply power to the device until all of the wiring is
completed.
The digital outputs and supply connections are designed to be isolated from each other.
Before commissioning the device, parameters must be set in accordance with desired use.
Incomplete or incorrect configuration can be dangerous.
The unit is normally supplied without a power switch, fuse, or circuit breaker. Use a power switch, fuse, and
circuit breaker as required by local regulations.
Apply only the rated power supply voltage to the unit, to prevent equipment damage.
If there is danger of serious accident resulting from a failure or defect in this unit, power off the system and
disconnect the device from the system.
Never attempt to disassemble, modify or repair this unit. Tampering with the unit may result in
malfunction, electric shock, or fire.
Please contact us with any questions related to the safe operation of this unit.
This equipment must be used in the manner specified in this instruction manual.
4 EN PROOP-IO 02 V08_1221